Publicidad
Idiomas disponibles
Idiomas disponibles
Purging and Priming the Sprayer
All new units are performance-tested at the factory and are shipped with test fluid in the fluid section to prevent
corrosion during shipment and storage. If you have already used your pump, some water or solvent used in cleaning
may remain in the fluid section. Whether your sprayer is new or if you have already used it, this fluid must be purged
and thoroughly cleaned out of the system prior to use. Follow the steps below.
1. Before priming, squirt a teaspoon of separating oil (P/N
0516914 included with unit) into the indicated area. Light
household oil can be substituted if necessary. Do not put
more than a teaspoon into the lubricating area. Too much
oil will leak down into your paint.
3. Place a full container of spraying material underneath the
suction tube (a). Secure the return tube (b) into a waste
container.
(a)
5. Plug in the sprayer and move the ON/OFF switch to the
ON (l) position.
The unit will begin to draw material up the suction tube,
into the pump, and out the return tube. Let the unit cycle
long enough to remove test fluid from the pump, or until
spray material is coming from the return tube.
English
(b)
2. Fully depress the pusher stem to make sure the inlet ball
is free.
4. Turn the pressure control dial to maximum pressure (+).
Turn the PRIME/SPRAY knob to PRIME.
6. Switch the pump OFF (O). Remove the return tube from
the waste container and place it in its operating position
above the container of spraying material. Use the metal
clip to bind the two hoses together.
8
Publicidad
