Publicidad
Idiomas disponibles
Idiomas disponibles
13. INSTALLATION AND CONNECTION WIRE
Before Starting
1.
This set is exclusively for use in vessels
with a negative ground 12V power supply.
2.
Read these instructions carefully.
3.
Be sure to disconnect the battery "
terminal before starting. This is to
prevent short circuits during installation.
(Figure 1)
General Cautions
1.
Do not open the case. There are no
user serviceable parts inside. If you
drop anything into the unit during
installation, consult your dealer or an
authorized Clarion service center.
2.
Use a soft, dry cloth to clean the case.
Never use a rough cloth, thinner,
benzine, or alcohol etc.
For tough dirt, apply a little cold or
warm water to a soft cloth and wipe
off the dirt gently.
"
Battery
Figure 1
Installing the Unit
NOTE: Make sure that the unit is
install securely in place. If the unit is
unstable, it may malfunction.
Trim Ring Installing
Attach accessory
Bend the tabs of
the mounting sleeve
with a screwdriver or
similar utensil and
attach it in place.
2
to the unit.
2
EN-15
Publicidad
