Publicidad
Idiomas disponibles
Idiomas disponibles
Installation (continued)
15
Making the water supply
connections
□
Use 1/2 in. I.P.S. faucet connections (2), or use
supply line coupling nuts (3) (not included) with
a 3/8 in. O.D. ball-nose riser (1).
NOTE: Before tightening the faucet connector to the water
supply, apply a second wrench to the supply tube tting.
This will prevent the supply tube from moving or twisting
when tightening the faucet connector. Do not overtighten.
Operation
1
Flushing and checking for leaks
IMPORTANT: After installation is complete, remove the aerator from the douche spray (G) to ush the water lines. Do not lose the
gasket (1) in the aerator.
□
Ensure the hot and cold valves (A & W) handles are in the off position, and turn on the water supply and
check for leaks. If you discover any leaks, check your connections to ensure they are installed properly.
□
Remove the aerator and housing (if applicable). Turn on the hot and cold handles to allow the water to run
for at least one minute. This ushes away any debris that could cause damage to internal parts.
□
Turn off the water and reinstall the aerator and housing (if applicable).
□
Turn the transfer valve body (K) handle to the right on the positions and ushes away any debris that could
cause damage to internal parts.
1
G
A
W
10
1
3
K
2
Publicidad
