Publicidad
Idiomas disponibles
Idiomas disponibles
Page 4 of 4
Assembly Instructions
3. Align the holes in the "U" bar, located underneath the seat frame (A-1), with the holes in the metal spring plates of the center
spring rail (D-1) of chair frame-1. Attach the seat frame (A-1) using the screws (H), metal plates (J), spring washers (I), and
nuts (K) as indicated. When attaching each seat frame, insert and start all four screws and nuts before completely tightening.
Once all four have been inserted, tighten each screw and nut using the hex wrench-1 (Q) and hex wrench-2 (R). After
securely tightening each of the screws, install the PVC hex head screw covers (O). See Figure 4.
Repeat Step 3 for the other chair using
seat frame (A-2).
Figure 4
4. Place the seat cushion (S), back cushion (T), and pillow (U) on each chair as indicated in Figure 1 on Page 1. Secure the
seat cushions to the chair frames using the attached straps with hook & loop fasteners. Note: The straps are not centered top
to bottom on the seat cushions, but instead sewn in the bottom half of the seat cushions. Place the seat cushions on the seat
frames with the straps towards the bottom.
Messina
TM
Concealed Motion Club Chair
! KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE !
Model #: 523116
Model #: 523120
Publicidad
