Hunter Engineering Company Edge QT Serie Instrucciones Funcionamiento página 5

ENGLISH ENGLISH
English
Getting Started Getting Started
General Introduction General Introduction
This manual provides operation instructions and information required
to operate the Quick Tread Edge™ system (console, sensors &
software) .
Hazard Definitions
Watch for these symbols:
CAUTION: Hazards or unsafe practices, which
could result in minor personal injury or product
or property damage .
WARNING: Hazards or unsafe practices,
which could result in severe personal injury
or death.
DANGER: Immediate hazards, which will
result in severe personal injury or death.
These symbols identify situations that could be detrimental to your
safety and/or cause equipment damage .
IMPORTANT SAFETY INSTRUCTIONS
Read all instructions before operating Quick Tread Edge™ . Read
and follow the instructions and warnings provided in the service,
operation and specification documents of the product .
Caution – Use of controls or adjustments or
performance of procedures other than those
Do not operate equipment with a damaged cord or equipment that
has been dropped or damaged until a Hunter Service Representative
has examined it .
To reduce the risk of electrical shock, do not use on wet surfaces or
expose to rain .
To reduce the risk of fire, do not operate equipment near open
containers of flammable liquids (gasoline) .
Read and follow all caution and warning labels affixed to your
equipment and tools . Misuse of this equipment can cause personal
injury and shorten the life of the unit .
Keep all instructions permanently with the unit.
Keep all decals, labels, and notices clean and visible.
Power off the unit and clean as required with a damp cloth .
Use equipment only as described in this manual .
Do not modify the unit or remove protective housings and covers .
No user serviceable parts inside . Service is to be performed only by
Hunter factory authorized personnel .
For Class 3R lasers, avoid direct eye exposure and specular
reflections .
Do not stare into laser beam or view directly with optical instruments .
Do not allow laser light to be directed or reflected toward people or
reflective objects .
3