Aerian AFH21 Manual De Instrucciones página 6

The fan heater has four modes :
0 Turn off the fan heater.
For fan only operation with no output of heat
I Set the fan heater to low heat mode (1000W).
Set the fan heater to high heat mode (2000W).
II
Please also turn the thermostat knob to the 'MAX' position.
4. To set the temperature, turn the thermostat knob to the desired position.
The thermostat control can be used to maintain your desired room temperature.
Once the room temperature feels comfortable, turn the thermostat knob slowly towards
the minimal position.
Safety Features
Tip-Over Protection
There is a tip-over switch fitted to the bottom of the fan heater. If the heater is accidentally tipped
over, the fan heater will stop operating. Once placed back into upright position, the fan heater will
switch on again.
Overheating Safety Device
The fan heater is fitted with a safety device that switches off the heater in the event of overheating.
Should the heater stops working, turn off the heater and inspect the air inlet and outlet for blockages.
Wait until the appliance cools down for the protection system to reset before restarting the heater.
CLEANING AND MAINTENANCE
Before cleaning, turn the mode control knob to the '0' position to turn off the fan heater and then
unplug it from the mains socket.
CAUTION: Allow the fan heater to completely cool before handling or cleaning it.
Clean the fan heater with a slightly damp cloth and be sure to completely dry the fan heater with a
soft cloth before using again.
Do not use abrasive or chemical cleaning agents.
Do not immerse the fan heater in water or any other liquid.
It is recommended to regularly vacuum the fan heater using a hose equipped with a brush
attachment. Gently vacuum dust accumulated inside the fan heater -- avoid disturbing the wires.
SPECIFICATIONS
Ratings: 220-240V~ 50-60Hz
1800-2000W
EN-5