Publicidad
Idiomas disponibles
Idiomas disponibles
CD PLAYER
Programming track numbers
Program in the STOP position to select and store your CD tracks in
the desired sequence. If you like, store any track more than once.
Up to 20 tracks can be stored in the memory.
1. Use the SEARCH ∞ or § on the set, (on the remote control
¡ or ™) to select your desired track number.
2. Press PROG.
™ Display:
and the selected track number.
PROG
briefly.
™ If you attempt to program without first selecting a track
number,
is shown.
3. Repeat steps 1-2 to select and store all desired tracks.
™
is displayed if you attempt to program more than 20
tracks.
4. To start playback of your CD program, press
PLAY•PAUSE 2; (on the remote control 2;).
™ If you have selected the tracks during CD play, first press
STOP 9, then PLAY•PAUSE 2;.
Reviewing the program
In the stop position or during playback, press and hold down PROG
for a while until the display shows all your stored track numbers in
sequence.
Erasing a program
You can erase the program by:
– pressing STOP 9 once in the STOP position;
– pressing STOP 9 twice during playback;
• The display shows
The program is also erased by:
– pressing the CD door open;
– selecting another source: TAPE / TUNER.
CD player and CD handling
• If the CD player cannot read CDs correctly, use a commonly
available cleaning CD to clean the lens before taking the set to
repair. Other cleaning methods may destroy the lens.
• The lens of the CD player should never be touched!
• Sudden changes in the surrounding temperature can cause
condensation to cloud over on the lens of your CD player.
Playing a CD is then not possible. Do not attempt to clean the
lens but leave the set in a warm environment until the
moisture evaporates.
• Always keep the CD compartment closed to avoid dust on the
lens.
14
briefly and
disappears.
PROG
appears
X
Publicidad
