Your AC generator was completely assernsble at the fac-
tory. It is ready for use after it has been properly serviced
with the recommended lubricating oil and fuel.,
IF YOU HAVE ANY PROBLEMS WITH THE ASSEMBLY
OF YOUR GENERATOR, PLEASE CALL THE GENERA-
TOR HELPLINE AT 1-800_222-3136.
IMPORTANT: ANY ATTEMPT TO RUN THE ENGINE
BEFORE tT HAS BEEN SERVICED WITH THE RECOM-
MENDED OIL WILL RESULT IN AN ENGINE FAILURE..
TO
Q
REMOVE GENERATOR
FROM CARTON
Set the carton on a flat rigid surface with "THIS SIDE
UP" arrows pointing upward.
°
Carefully open the top flaps of shipping carton_
°
Cut down corners at one end of shipping carton and
lay that side of carton down flat.
-
Remove packing material, carton fillers, etc_.
°
Remove the generator from the shipping carton°
TO ADJUST HANDLE GUIDE
Your generator is equipped with a wheel kit for easy man-
ueveringo After' you remove the generator from the carton
Lifthandle into upright position and push the black slides
down to hold the handle in position. The handle may be
lowered for easier' storage.
CORD SETS AND CONNECTOR
PLUGS
120 VOLT CORD SETS
use only high quality, wefl-insutated, extension cords with
the generator's 120-volt type electrical receptacle&
Each receptacle of this pair is protected against overload
by a single 20-amp push-to-reset
type of circuit breaker°
Use each receptacle to operate 120 volts, single phase
60 Hz, A C electrical loads requiring up to 2400 watts (2.4
kW) at 20 amps of current_
!
Figure-1
Check the ratings of all extension cords before you use
them Extension cord sets used should be rated 125 volts
at 20 AC amps or greater' for' most electrical devices..
Some devices, however, may not require this type of
extension cord° Check the owner's manual of those
devices for the manufacturer's
recommendations.
CAUTION: Althougheach receptacleis rated for 120
voltsat 20 amps(2400 watts or 2A KW), the generator
is rated for a total of 2500 watts. Poweringloadsthat
exceed the wattage capacityof the generatorcan dam-
age it or causeserious injuries. The total loadswith
120 volts powered thoughthese receptaclesshouldnot
exceed20 amps.
Keep extension cords as short as possible, preferably
less than 15 feet long to prevent voltage drop and possi-
bly overheating of wires.
12 VOLTS DC 10 AMP BATTERY CHARGE OUTLET
Figure-2
The 12 VOLT DC outlet has a unique configuration that
will only allow the 12 volt wire harness to be inserted,
When the 12 volt harness is properly inserted the red wire
wil! be positive 12 volts and the blackwire will be negative_
DO NOT modify any plug to make it fit this outlet or dam-
age to the generator may result.
4