Publicidad
Idiomas disponibles
Idiomas disponibles
ASSEMBLY INSTRUCTIONS
7. Assemble
Head Base Plate [H]
into the Kraken
Head [E] using the included screws [AA]. Flip
the head upside down, placing it on a soft
surface that will not scratch the paint. Align the
holes on the base of the Kraken Head [E] with
the threaded holes of the frame, as shown in the
diagram. Use a Phillips head screwdriver to
assemble the four screws into place, securing
Head Base Plate [H] to Kraken Head [E].
Hardware Used
M6 x
18
mm
AA
Screw
(x4)
Tools Required
8. Place
Tentacle Base Plate [I]
into the Tentacle
Base [A], aligning the screw holes as shown in
the diagram. Use a Phillips head screwdriver to
assemble the three screws into place, securing
Tentacle Base Plate [I] to Tentacle Base
[A].
Hardware Used
M6 x
18
mm
AA
Screw
(x3)
Tools Required
7
AA
E
8
AA
I
6
ASSEMBLY INSTRUCTIONS
9. Place
Tentacle Base Plate [J] into Tentacle
Base
[C], aligning the screw holes. Use a
Phillips head screwdriver to assemble the three
screws into place, to secure the bracket.
Hardware Used
AA
H
Tools Required
10. Attach the female ends of the wiring harness
[N] to the male wires at the bottom of each
Kraken part as shown in the diagram below.
Fasten the threaded collar to secure each
connection.
Connect the two-pronged connector from the
controle module to power adapter.
You may power the product at this stage to
make sure each of the components light up.
A
G
N
9
AA
M6 x
18
mm
Screw
(x3)
10
N
A
E
C
7
J
C
L
F
M
Publicidad
