Kenwood LS-K1000 Manual De Instrucciones página 4

Connections
Each speaker of this speaker system can be connected to
either the left or right output channel of the amplifi er.
CAUTION
Be sure to turn off your amplifi er before connecting or
disconnecting speakers.
1 Twist wire's conductor
2 Loosen 3 Insert the
Right
Wire with white line
Speaker terminals
(amplifi er or receiver)
Note on connection
• Never short the (+) and (–) speaker wire's conductors to-
gether.
• Do not reverse L and R or (+) and (–) connections. Reversal
of sides or polarities may result in unnatural, incorrectly
positioned sound.
4
4 Secure
conductor
The speaker wire can also be connected to the speaker
by using banana plugs which are commercially available
in audio stores.
To use the banana plug connection, tighten the screws
on the speaker terminals before inserting the banana
plug.
1
Maintenance
Maintenance of the unit
When the speaker cabinets get dirty, wipe with a soft, dry
cloth.
Do not use thinner, benzine, alcohol, etc. for these agents
may cause discoloration.
Left
In regard to contact cleaner
Do not use contact cleaners because it could cause a mal-
function. Be specially careful not to use contact cleaners con-
taining oil, for they may deform the plastic component.
Specifi cations
System ......................................... 2-Way 2-Speaker System
Enclosure ................................................... Bass-Refl ex type
Loudspeakers
Woofer .......................... 120 mm (4-3/4 ") Cone type
Tweeter ..................................25 mm (1 ") Dome type
Nominal Impedance ........................................................6 Ω
Nominal Input Power .................................................... 40 W
Maximum Input Power ................................................. 80 W
Sensitivity .................................................... 85 dB/W at 1 m
Frequency Response .............................. 48 Hz ~ 45,000 Hz
Crossover Frequency .............................................. 2,000 Hz
Dimensions .................................. Width : 168 mm (6-5/8 ")
Net Weight ........................................ 5.2 kg (11.5 lb) / piece
Note :
Kenwood follows a policy of continuous advancements in
development. For this reason specifi cations may be changed
without notice.
Connections
2
(Magnetically shielded)
Height : 305 mm (12 ")
Depth : 270 mm (10-5/8 ")