PATONA PREMIUM COB-300APRC Manual página 13

1. Remote Control Overview
1
LCD display
2
CH / GRP button
3 Plus button
4 Minus button
5 ON / OFF button
6
Set button
7 Battery cover
2. Remote Control On / OFF
• Removing the Battery Cover: Forcefully slide the battery cover off the remote control in
the direction indicated by the arrow.
• Installing Batteries: Insert two AAA batteries into the battery compartment, aligning them
according to the positive (+) and negative (-) symbols.
• Replacing the Battery Cover: Slide the battery cover back into place, opposite to the
direction of the arrow, and secure it.
• Turning on the Remote Control: Press and hold the ON/OFF button on the remote control
for one second. The LCD display will illuminate, indicating that the remote control is active.
• Backlight and Shutdown:
○ If the remote control is not used for 15 seconds after being turned on, the backlight will
turn off. Press any button to reactivate the backlight.
○ To turn off the remote control, press and hold the ON/OFF button for one second.
3. Remote Control Channel and Group Settings
• Power On: Turn on the remote control.
• Accessing Group and Channel Settings:
○ Press the "CH/GRP" button once to make the group indicator flash, indicating you can set
the group.
○ Press it again to make the channel indicator flash, allowing you to set the channel.
○ Press it a third time to exit the setting mode.
• Setting the Group:
○ While the group value is flashing, press the "+" and "-" buttons to select one of the four
modes: A, B, C, or ABC. The remote control can manage three groups of lights labeled A,
B, and C.
• Setting the Channel:
○ While the channel value is flashing, use the "+" and "-" buttons to set the channel number.
12