Vonyx WM55B Manual De Instrucciones página 3

UNPACKING INSTRUCTION
CAUTION! Carefully unpack the box upon receipt. Check the contents to ensure that all parts are present and have been
received in good condition. Notify the shipper immediately and retain packaging material if any parts appear damaged from
shipping or the package itself shows signs of mishandling. Save the package and all packaging materials. If the product must be
returned, it is important that the product is returned in the original factory box and packaging.
If the device has been exposed to drastic temperature fluctuation (e.g. after transportation), do not switch it on immediately. The
arising condensation water might damage your device. Leave the device switched off until it has reached room temperature.
POWERSUPPLY
The label on the back/under side of the product indicates the mains voltage to which it must be connected. Check that the mains
voltage corresponds to this. Any other voltage than the one indicated may cause irreparable damage to the unit. The unit must
also be connected directly to the mains voltage and no dimmer or adjustable power supply may be used.
Always connect the device to a protected circuit (circuit breaker or fuse). Make sure the device has an appropriate
electrical ground to avoid the risk of electrocution or fire.
OVERVIEW
1. DISPLAY
Display showing frequency, battery status and reception.
2. ON/OFF / VOLUME SWITCH BODYPACK
Rotate to turn the bodypack on/off or change the volume.
3. MICROPHONE INPUT
3.5mm microphone jack input.
4. SET
Press to manually sync the bodypack with the receiver.
5. BATTERY COMPARTMENT 2X AA 1.5VOLT
Compartment for 2x AA type batteries.
6. BATTERY COMPARTMENT 1X18650 3.7VOLT
Compartment for 1x18650 type battery.
7. ON/OFF SWITCH RECEIVER
Slide to turn the receiver on/off.
8. RF
Sync indicator. Shows pairing status.
9. USB CHARGE PORT
5V USB connector for charging the receiver's battery.
10. CHARGE INDICATOR
Indicator showing charge status.
11. ANTENNA
OPERATION
• Open the battery cover (7) of the microphone receiver and insert the supplied battery. Charge the battery of the receiver using
the supplied USB cable via USB charging port (10).
• Open the battery compartment lid of the bodypack and insert 2x AA 1.5Volt batteries (6), note the polarity!
• Insert the receiver in a 6.3 mm microphone jack of, for example, a mixer, active speaker, amplifier, etc.
• Switch on the receiver (8) and microphone (2).
• Synchronisation between microphone and receiver will initiate automatically.
• If the channel is busy or interfering, you can change it manually by pressing the SET button (4).
FIRST TIME PAIRING
• Turn off both units.
• Turn on the bodypack whilst holding the SET button.
• The display will start to flash. Release the switch (display will continue to flash).
• Turn on the receiver. The RF light will flash several times before staying lit. The receiver has briefly made contact with the
microphone.
• Turn the microphone off and on again, the units should be paired.
3