Publicidad
Idiomas disponibles
Idiomas disponibles
GB
MT
Description of functions
The cordless hedge trimmer features a
high-quality knife made from special laser-
cut steel. When trimming, the cutting teeth
move to and fro in a linear shearing mo-
tion. The strike guard at the tip of the knife
prevents unpleasant kickback reactions
when hitting walls, fences, etc. Operat-
ors are protected by the appliance's two-
hand safety switch and quick-stop brake
function. The hand protection guards your
hands against twigs and branches. The
clippings collector clears the clippings
from the hedge for horizontal cutting.
Read the sections below to learn more
about each operating element's function.
Technical data
Cordless Hedge Trimmer 40V
............................. PPHSA 40-Li B2
Rated voltage U ...........40 V ⎓ (2 x 20 V)
Weight with battery
(2 × Smart PAPS 204) ................. ≈4.6 kg
No-load rotation speed n
Stroke rate n
........................ 1800 min
max
Cutting movements
–level 1 .....................................2000 min
–level 2 .....................................3000 min
–level 3 .....................................3600 min
Cutting length ............................. ≈580 mm
Blade length (including stop protection)
......................................................≈600 mm
Blade tooth spacing ......................≈24 mm
Branch diameter ............................≤19 mm
Sound pressure level (L
...................................... 82.4 dB; K
Sound power level (L
– Guaranteed ...................................96 dB
– Measured ......... 93.4 dB; K
Vibration (a
) ....... 1.76 m/s²; K=1.5 m/s²
h
Battery ................................................. Li-Ion
28
-1
.......2800 min
0
-1
-1
-1
-1
)
pA
=3 dB
pA
) ............................
WA
=2.29 dB
WA
Temperature ................................... ≤50 °C
– Charging ..................................4–40 °C
– Operation ........................... −20–50 °C
– Storage .................................... 0–45 °C
PARKSIDE Performance Smart battery
Smart PAPS 204 A1/Smart PAPS 208 A1
– frequency band .... 2400–2483.5 MHz
– transmitted power .................... ≤20 dBm
Levels of noise and vibration were determ-
ined according to the standards and regu-
lations in the declaration of conformity.
The specified total vibration value and the
stated noise emission value have been
measured according to a standardised
test method and can be used to compare
one power tool with another. The specified
total vibration value and the stated spe-
cified noise emission value can also be
used for a provisional assessment of the
load.
WARNING! The vibration and noise
emissions may deviate from the specified
values during actual use of the power tool,
depending on how the power tool is be-
ing used. Try to keep the exposure to vi-
brations as low as possible. An example
of a measure to reduce vibration exposure
is limiting the working hours. All parts of
the operating cycle have to be considered
while doing so (for example, times when
the power tool is switched off and times
when it is switched on but running without
any load).
Charging time
The device is part of the X 20 V TEAM
series and can be operated with bat-
teries of the X 20 V TEAM series. Bat-
teries of the X 20 V TEAM series may
only be charged using chargers of the
X 20 V TEAM series.
We recommend that you operate
this appliance with the following bat-
Publicidad
