LG LGWADREM7150 Manual Del Propietário página 38

38 TROUBLESHOOTING
Problem
Eb
CLUTCH ERROR
Ps
SUPPLY VOLTAGE
ERROR
Noises
Problem
Clicking
Spraying or hissing
Humming or
Gurgling
Water sloshing
Water being added
after the washer has
already begun to
operate
Rattling and
clanking noise
Thumping sound
Vibrating noise
Clutch error
• Mechanical failure
• Unplug the washer and call for service.
Supply voltage is not correct.
• Please call LG service center. You can find your local LG service center phone number on
the back cover page.
Lid lock sounds when the lid locks or unlocks.
• Normal operation
Water spraying or circulating during the cycle
• Normal operation
Drain pump is pumping water from the washer at times during a cycle.
• Normal operation
A liquid in the balance ring around the pulsator helps the basket spin smoothly.
• Normal operation
The washer adapts to the load size and type to add more water to the cycle as needed.
• Normal operation
The wash load may be unbalanced. If the washer senses that the load is unbalanced, it
will stop and refill to redistribute the load.
• Normal operation
The washer may be diluting laundry additives to add to the wash load.
• Normal operation
Foreign objects, such as keys, coins, or safety pins may be in tub or pump.
• Stop the washer, check the tub and the drain filter for foreign objects.
• If noise continues after the washer is restarted, call for service.
Heavy wash loads may produce a thumping sound.
• This is normal, but if the sound continues, the washer is probably out of balance. Stop and
redistribute wash load.
Wash load may be out of balance.
• Pause the cycle and redistribute the load after the lid unlocks.
Packaging materials were not removed.
• See Unpacking and Removing Shipping Material in INSTALLATION.
Wash load may be unevenly distributed in the tub.Wash load may be unevenly
distributed in the tub.
• Pause the cycle and redistribute the load after the lid unlocks.
Not all leveling feet are resting firmly and evenly on the floor.
• See Leveling the Washer in INSTALLATION.
Floor is not rigid enough.
• Make sure that the floor is solid and does not flex. See Flooring in INSTALLATION.
Possible Cause & Solution
Possible Cause & Solution