Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
When using electric tools and
their accessories, always follow basic safety
precautions to reduce the risk of fire, electric shock
and personal injury, including the following:
BEFORE USING THIS ACCESSORY, READ
AND UNDERSTAND THE INSTRUCTION
MANUAL THAT CAME WITH THE VACUUM
• Do not allow the accessory to be used as a toy.
Pay close attention when the accessory is used
by or near children.
• Use this accessory ONLY as described in the
manual. Use only D
attachments.
• To reduce the risk of heal hazards from vapors or
dust, do not use dust separator with toxic materials.
Do not use or store near hazardous materials.
• To reduce the risk of injury from accidental starting,
always shut off vacuum and disconnect the power
plug from the wall outlet before connecting the
dust separator to the vacuum.
• Wood dust mixtures are highly ammable and can
be explosive.
• NEVER introduce sparks or sources of ignition
into collector.
• Do not use the accessory to pick up ammable or
combustible liquids, such as gasoline, or use in
areas where ammable or combustible liquids
are present.
WARNING:
This product can expose people
to chemicals including lead, which is known to the
State of California to cause cancer, birth defects or
other reproductive harm. For more information go to
www.P65Warnings.ca.gov
WALT recommended
E
THE DUST SEPARATOR IS MADE
OF STATIC DISSIPATING PLASTIC
INSTALLATION OF DUST
SEPARATOR TANK
1. Place dust separator tank into the recess
(4) on the lid, ensuring that the ribs (2) are
aligned with the slots (3).
2. With the lid in an upside down position,
insert provided screws (1).
3. Use screwdriver (not included) to secure
and tighten the screws.
NOTICE:
The ribs (2) on both sides of the
separator must be aligned with the two
small slots (3) in the recess of the cover.
Recess
(4)
CASTER INSTALLATION
1. Invert the dust tank and install the casters
to the bottom of the dust tank and x them
with screws( ST3.9 x 16F ).
2. Return dust tank assembly upright.
2
ST4.8 x 16F
(1)
Ribs
(2)
Slots
(3)
Publicidad
