Publicidad
Idiomas disponibles
Idiomas disponibles
Keys
(2) Keys
Slope Sheet
ii iiiiill
Your new tractor has been assembled at the factory with the exception of those parts left
unassembied for shipping purposes.
TOOLS REQUIRED
FOR ASSEMBLY
A socket wrench set wiltmake assembly
easier, Standard wrench sizes are listed.
(1) 1/2" wrench
Tire pressure gauge
(2) 7/16" wrenches
Utility knife
Pliers
When right or left hand is mentioned in this
manual, itmeanswhenyouareintheoperating
position (seated behind the steering wheel).
TO REMOVE TRACTOR
FROM
CARTON
UNPACK CARTON
•
Remove all accessible loose parts and
parts cartons from carton.
•
Cut along dotted lines on all four pan-
els of carton, Remove end panels and
lay side panels flat,
.
Check for any additional loose parts or
cartons and remove.
BEFORE REMOVING
TRACTOR
FROM
SKID
J
abel
ADJUST SEAT
t, Sit in seat,
2. Lift up adjustment lever (A) and slide
seat until a comfortableposition is
reached which allows you to press
clutch/brake pedal all the way down,
3. Release lever to lock seat in position.
TO CHECK BATTERY
1, Lift hood to raised position.
NOTE: Ifthis battery is putinto service after
month and year indicated on label (label is
located between terminals) charge battery
for minimum of one hour at 6-10 amps. (See
"BATTERY" in Maintenance section of this
manual for charging instructions).
•
For battery and battery cable installation
see "REPLACING
BATTERY" in the
"Service and Adjustments" section inthis
manual.
NOTE: You may now roll yourtractor off
the skid. Foi}ow the appropriate instruction
below to remove the tractor from the skid.
WARNING: Before starting, read, un-
derstand and follow all instructions in the
Operation section of this manual. Ensure
tractor is in a weLl-ventilated area. Ensure
the area in front of tractor is clear of other
people and objects.
7
Publicidad
