Selecting To Taste - Sound; Optimizing Your Sound - Sound Menu; Hdeq Tuning - Sony CDX-GT800D Manual De Instrucciones

Selecting to taste — SOUND
You can set up in various ways, selecting the
preset of HDEQ, DSO 3D and I-TA.
1
Press (SOUND) repeatedly to select
your desired item during playback.
The items change as follows:
HDEQ t DSO 3D t I-TA t Balance
t Fader t Sub Woofer
2
Rotate the volume control dial to
select the setting.
After about 3 seconds, the setting is complete.
With the card remote commander
In step 2: press < or , to adjust tuning HDEQ, DSO
3D and I-TA precisely. See page 13 and 14 for further
information.
Optimizing your sound
— Sound MENU
You can precisely optimize the setting of HDEQ,
DSO 3D and I-TA to your taste and according to
your car interior, using the Sound MENU. See
also "Precisely adjusting your sound" (page 15).
BBE MP is also adjustable. The menu method is
common to each feature - learn the procedure
below, then proceed to each feature.
1
Press (MENU) during playback.
2
Rotate the SEEK control dial until
"SOUND" appears.
3
Press (ENTER).
4
Rotate the SEEK control dial to select
an item, then press (ENTER).
5
Repeat step 4 to adjust other items.
6
Press (MENU).
The setting is complete.
With the card remote commander
In steps 2 and 4: press M or m to adjust the selected
item.

HDEQ Tuning

The equalizer curve is precisely adjustable for
frequency and volume level. Tuning consists of 4
channels: Front L/R and Rear L/R.
1
Select "SOUND" t "HDEQ" in MENU
mode.
2
Select "Custom1," "Custom2" or
"Custom3" to store.
3
Select the equalizer curve you wish to
adjust.
In your chosen Custom setting the equalizer
curve can be adjusted, then a pencil icon will
appear as "Custom1" t "Custom1
4
Select the speaker to adjust.
5
Adjust the equalizer curve to your
taste.
1 Press (ENTER) to select the frequency
you wish to adjust (adjustable from 63 Hz
to 16 kHz in 13 bands).
2 Rotate the SEEK control dial to adjust the
level of the chosen frequency (1 dB steps
from –6 dB to +6 dB).
3 Repeat steps 1 and 2 to adjust other
bands of the equalizer curve.
6
Confirm your settings using the
confirmation screen, and save the
value.
7
Repeat steps 3 to 6 until all the
speakers have been set.
Note
The pencil icon appears only after selecting the preset
in step 3, however, until it is saved in step 6, the
adjustment will not be applied.
Tip
Select "Reset" in step 4 to reset the default setting
(flat).
With the card remote commander
In 1 of step 5: press < or , to adjust the
frequency; in step 2: press M or m to adjust the level.
continue to next page t
."
13