Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Top Panel
1.
Outputs: Use standard 1/4" TRS cables to
connect these outputs to a speaker or
amplifier system. The level of these outputs
is controlled by the Volume knob.
2.
Aux In: Use a standard 1/8" stereo cable to
connect this input to an optional audio player
(e.g,. MP3 player, CD player, etc.). This
audio will be heard in the Outputs and
Phones output. During recording, the audio from this input will not be recorded.
3.
Tom 4 Input: Use a standard 1/4" TRS cable to connect this input to an optional drum pad, which will
trigger the Tom 4 sound.
4.
Crash 2 Input: Use a standard 1/4" TS cable to connect this input to an optional cymbal pad, which will
trigger the Crash 2 sound.
5.
MIDI Out: Use a standard five-pin MIDI cable to connect this output to the MIDI In of an external MIDI
device.
6.
MIDI In: Use a standard five-pin MIDI cable to connect this input to the MIDI Out of an external MIDI
device.
7.
USB: This connection will allow you to send MIDI information to a computer. Use a USB cable (sold
separately) to connect the module to an available USB port on your computer.
Note: Only MIDI information is sent over the USB connection, not audio.
Side Panels
1.
Power Connection: Connect the included
power adapter (9V DC, 500mA, center pin-
positive) here, then connect the adapter to
wall power.
2.
Power Button: Press this button to turn the
module on. Press and hold it for a second
then release it to power the module off.
3.
Phones: Connect a set of 1/8" stereo
headphones to this output.
Note: To save energy, the drum module will shut down automatically after 30 minutes of no activity. If you do
not need this feature or want to adjust the shutdown time, do the following:
1.
Power on the drum module.
2.
Press Utility.
3.
Use the < / > buttons to select the Power Page (POW).
4.
Use the < / > buttons to adjust the shutdown time (30 – 60 minutes, or OFF).
7
5
6
3
5
4
3
1
1 2
1
2
Publicidad
Tabla de contenido
