Publicidad
Idiomas disponibles
Idiomas disponibles
CAUTION: For deep cuts in hard materials, it is recommended to pre-cut about 20mm before performing
the final full depth cut. This will be faster, more efficient and less stressful to the motor.
VACUUM DUST COLLECTION
There is a vacuum port provided on the blade cover to collect dust
when operating. Always make use of it. Simply attach the vacuum
cleaner hose to the vacuum port.
STARTING AND STOPPING TOOL
To switch on:
This machine has a lock-off type switch. First press the trigger release,
then squeeze the trigger switch to switch on. For safety reasons, the
switch is not possible to lock on.
To switch off:
Release the trigger switch to stop the machine. After the machine has
been switched off, the blade will still rotate for a time, take care that
parts of your body do not come into contact with the blade while it is
still rotating.
LOAD WARNING, OVERLOAD PROTECTION AND OVERHEAT PROTECTION
Load Warning Light:
Whenever the unit is plugged in, the light will be lit solid green.
When the load on the motor is in the maximum range, the light will flash red.
When the motor is overloaded or overheated, the light will be lit solid red.
Load Warning Function:
When maximum load is exceeded, the load warning function will
operate, causing the motor to pulsate. When this happens, the operator
should decrease the force on the tool, and it will return to normal
operation automatically. If the load is not decreased, the motor will
shut down and the load warning light will be lit solid red. In this case,
the motor must be restarted by turning the switch OFF and then back
ON.
Overheat Thermal Protection:
If the temperature of the motor gets too high, the thermal protection will shut the motor down and the load
warning light will be lit solid red. The motor must be restarted by turning the switch OFF and then back ON.
When this happens, do not immediately put a load on the motor after restarting. Always run the machine at no
load for a few minutes to return to a normal operating temperature before continuing.
C
AUTION: The motor will be damaged if it is repeatedly overloaded or overheated. Always cool the
motor by running at no load for a few minutes whenever it stops from either overheat or overload.
GB
Dust Port
Switch Trigger
11
Trigger Release
Load Warning Light
Publicidad
