Publicidad
Idiomas disponibles
Idiomas disponibles
Operation (continued)
Using the heater control
NOTE: The heater default temperature is set to 82 degrees Fahrenheit. If your ambient room temperature is above 82
degrees, then your heater will automatically shut off after few minutes. Set your heater to ALWAYS ON (see below
directions) in order to keep your heater ON above 82 degrees.
□
Pressing the heater button (4) will turn on or off the heat and set the temperature in the thermostat. If you turn off
the heater by the main power button (6), the unit will hold your preferred temperature setting in the memory. When the
power is turned back on, the heater will turn on at the same setting. There is no speed setting for the heater blower.
□
To convert from Fahrenheit to Celsius: With the heater on, press and release the heater button (4) so that the
display (1) and LED function indicator (2) lights turn on (if they are not already on). Then gently press and hold the
main power button (6) for five seconds to enter temperature converting mode. The LED indicator flashes five times in
red color then changes to green. Green indicates Celsius mode, and Red indicates Fahrenheit mode. In this converting
mode, the display (1) flashes. Repeat the same process to convert Celsius temperature into Fahrenheit temperature.
□
To set the thermostat temperature: Press the heater button multiple times to cycle through the temperature
settings, starting at 82°F down to 62°F, then Always OFF or Always ON. (27°C - 17°C - OFF - ON). After you release
the heater button (4), your preferred setting will be flashing. Once it stops flashing, and the display goes dark, then
the thermostat will be set at your preference (and kept in memory). Note that the "ON" setting keeps the heater
always on until the user powers off the unit or the safety sensor turns off the heater to prevent overheating.
To turn OFF the Heater while keeping the Flames ON: Press the heater button multiple times until you see "OF"
□
in the Control Panel display (1). This indicates the Heater is "OFF". Flame settings and other features continue to
operate as normal.
□
Heater Lock (safety feature): To lock the heating function in the OFF position, with the main power button on, press
and hold the heater button (4) for at least ten seconds while counting to twenty-five. In this mode, there is no heater
function, but flame control operates normally. To unlock the Heater Lock, follow this same procedure. Then normal
heater mode is tuned back on.
NOTE: After the heater function or power is shutoff the blower will continue to run for several minutes to cool the
internal components.
1
2
Using the flame control
□
Press the flame button (5) to set the flames for different levels of flame brightness. These flame levels are shown
in the display (1). The flames cannot be turned off when the heater function is on. The flame settings are as follows:
Button Press
1st press
2nd press
3rd press
4th press
5th press
□
Regardless of the previous flame setting, when powered off by the main power button, the flames will come on in
L4 mode (High) when you turn the heater on.
4
6
Flame Level
High
Medium
Low
Lowest
Off
5
Display Value
Fireplace Appearance
L4
Flames Highest
L3
Flames Medium
L2
Flames Low
L1
Flames Lowest
None
Flames Off
5
Lowes.com/allenandroth
Publicidad
