Publicidad
Idiomas disponibles
Idiomas disponibles
KNOW YOUR SAW
READ THIS INSTRUCTION MANUAL AND SAFETY RULES BEFORE OPERATING YOUR
CHAIN SAW. Compare the illustrations
with your unit to familiarize
yourself
with the
location of the various
controls and adjustments.
Save this manual for future ref-
erence.
Chain
Adjustment Tool
Front Hand Guard
(Bar Tool)
Chain
Muffler
Bar Oil Fill Cap/S
er
Housin(
Front Handle
Starter Rope
ON/STOP
Switch
Primer
Bulb
Fuel Mix Fill Cap
Cylinder Cover
Throttle
Lockout
Rear
Handle
Chain
Direction
of Travel
Throttle
Choke/
Chain
Brake Nuts
Guide Bar
Trigger
Fast Idle
Chain
Chain
Lever
Brake
Catcher
Sprocket
Hole
ON/STOP
SWITCH
The ON/STOP SWITCH is used to stop
the engine.
THROTTLE
TRIGGER
The THROTTLE TRIGGER controls
en-
gine speed.
THROTTLE
LOCKOUT
The THROTTLE LOCKOUT must be
pressed before you can squeeze the
throttle trigger. This feature prevents you
from accidentally
squeezing the trigger.
CHOKE/FAST
IDLE LEVER
The choke and fast idle are set by pull-
ing the CHOKE/FAST IDLE LEVER out
fully for cold or after refueling.
The
choke provides
additional
fuel to the
engine during cold starting.
PRIMER BULB
The PRIMER BULB circulates
fuel to the
carburetor
to provide quicker
starting.
CHAIN BRAKE
The CHAIN BRAKE is a device de-
signed to stop the chain if kickback
oc-
curs. The chain brake activates
auto-
matically
in the event of kickback.
The
chain brake activates
manually
if the
front hand guard is pushed forward.
The chain brake is disengaged
by pull-
ing the front hand guard back toward
the front handle as far as possible.
CHAIN TENSION
It is normal for a new chain to stretch
during first 15 minutes of operation. You
should check your chain tension fre-
quently. See CHAIN TENSION under the
SERVICE AND ADJUSTMENTS section.
Publicidad
