Publicidad
Idiomas disponibles
Idiomas disponibles
English
Phono/Line Switch
For increased flexibility of use, this unit has a built-in stereo phono pre-amplifier.
If you prefer to use the phono input of your stereo system or your standalone
phono pre-amplifier, set the Phono/Line switch to the PHONO position.
Otherwise, please set it to LINE position and make connection to the AUX input
or other high-level input on your stereo system.
Stereo System Connection
RCA Jacks
• The RCA Jacks of this unit can be used as either Phono output jacks or Line
output jacks. This is determined by using the Phone/Line Switch.
• To connect to active speakers, set Phono/Line switch to Line setting. To
connect to a phono pre-amp or the phono input of a stereo system, set
Phono/Line switch to Phono setting.
• The Red plug connects with the Right channel and the White plug connects
with the Left channel.
Note:
− If the Phono/Line switch is set at LINE position but RCA jacks connected to the
stereo system's phono input, the sound might be distorted due to input overload
and could damage your stereo system.
− If the Phono/Line switch is set at PHONO position but RCA jack connected to the
stereo system's line input, the volume will be very low due to lacking signal pre-
amplification.
− RCA Jack is not designed to be connected directly to the passive/unpowered
speakers and if it does, the volume will be very low.
Spring clip speaker terminals
To connect to the speakers included with this system or other passive speakers,
connect one end of the speaker wire included with this package to the back of
the speakers and the other end to the Speaker Output Terminals. To do this, flip
the spring clips to the open position, insert the speaker wire, and flip the spring
clips to the closed position. Set the Phono/Line Switch to Line setting.
6
Publicidad
