Electrolux CI1301 Manual De Instrucciones página 12

12 www.electrolux.com
Problem
The compressor operates
continually.
There is too much frost
and ice.
The compressor does not
start immediately after
pressing the "FastFreeze",
or after changing the tem‐
perature.
Temperature cannot be
set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The temperature in the ap‐
pliance is too high.
Temperature is set incor‐
rectly.
Many food products to be
frozen were put in at the
same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor‐
rectly.
The FastFreeze function is
switched on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
The "FastFreeze function"
is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
Solution
Refer to "Door Open
Alarm"or "High Tempera‐
ture Alarm".
Refer to "Operation" chap‐
ter.
Wait a few hours and then
check the temperature
again.
Refer to climate class chart
on the rating plate.
Allow food products to cool
to room temperature be‐
fore storing.
Refer to "Closing the door".
Refer to "FastFreeze func‐
tion".
Refer to "Closing the door".
Position the water drain‐
age plug in the correct
way.
Wrap the food products
better.
Refer to "Operation" chap‐
ter.
The compressor starts af‐
ter a period of time.
Switch off "FastFreeze
function" manually, or wait
until the function resets au‐
tomatically to set the tem‐
perature. Refer to "Fast‐
Freeze function".
Set a higher/lower temper‐
ature.
Refer to "Closing the door".