Drive AQUAJOY PREMIER PLUS Instrucciones De Funcionamiento página 9

REV.9
HOW TO BATHE WITH YOUR AQUAJOY PREMIER PLUS BATHLIFT
After easily installing your AQUAJOY PREMIER PLUS BATHLIFT attach the
connector of the fully charged battery hand control to the connector on the back of
the backrest.
Take hold of the battery hand control and press the "up" button. Continue to press
and the bathlift will rise up. When the bathlift becomes flush with the top level of
your bath, release your finger from the "up" button and the bathlift will stop moving.
Sit on the sideflap of the bathlift seat (this should be resting flat on the side of your
bath) with your legs against the bath. Slide / shuffle over to the middle of the seat
and lift one leg at a time over the side of the bath. Swivel round so that you are
sitting in the correct position for comfortable bathing. (If you have problems
sliding/shuffling over, why not try our "AQUAJOY SWIVEL & SLIDE
ACCESSORY".)
By pressing the "down" button on your hand control the bathlift will lower you to
your required bathing position.
The bathlift will take you safely and comfortably to the bottom of the bath. At the
bottom, you will be sat at a 20 degree angle. If you want to recline when you are at
the bottom of the bath, simply continue to press the "down" button and the bathlift
backrest will recline. (You can recline up to a maximum of 40 degrees)
You can stop reclining at any time if you simply stop pressing the "down" button.
When you have finished bathing, simply press the "up" button on your battery
hand control. Continue to press the "up" button until the bathlift is flush with the top
of your bath. Please make sure the sideflap rests flat on the side of the bath when
transferring off the Bathlift.
20 Degrees 40 Degrees
HOW TO REMOVE YOUR AQUAJOY PREMIER PLUS BATHLIFT FROM YOUR
BATH TUB
27 Degrees
9