User's Manual
and/ or windows
The unit is not to be situated under a roof-mounted ventilation system.
The unit should have sufficient space to 'breathe' (always use the rear space to ensure minimum
clearance).
The unit should not be placed under direct sunlight.
Keep all ventilation openings in the appliance enclosure or in the structure clear of obstruction.
In order to reduce fire hazard, the installation of this appliance must be carried out only by a
suitably qualified person.
Levelling the unit :
Place the unit at the chosen location. Using a spirit level, check whether the unit is levelled in both
directions.
The spirit level can be placed on one of the shelves.
It is essential that the unit is levelled during operation so as to avoid possible ice formation on the
evaporator's fins due to insufficient drainage of the condensates.
Tilt unit by 2° angle for easy closing of door and drain.
Do not insert cream or spray bottles inside the chiller.
Do not store explosive substances such as aerosol cans with flammable propellant in the chiller.
Ⅳ、Product Features
1. It uses quality, effective and hermetic compressor with broad range of starting voltage, suitable
ambient temperature: not higher than 104℉, reasonable matching of the chiller system guarantees
its powerful refrigerating ability and energy saving.
2. The thermal insulation layer of the chiller made from hard polyurethane foamed plastics makes it
be light and good ability to keep the contents cold.
3. This equipment is intended for the storage and display of packaged products only.
Ⅴ、Operation of the Temperature control button
1. The temperature can be controlled by the temperature control button.
2. Press the SET key 3s,then press
3. Press the
key 3s,the device enters the forced defrosting mode .
Alarm code
E1
E2
rH
rL
or
key to adjust the temperature.
Cause of alarm
The cabinet temperature sensor is faulty
Evaporator sensor fault
Cabinet temperature high temperature alarm
Cabinet temperature Low temperature alarm
7