HAMPTON BAY PINE VALLEY ALF07717K01 Guía De Uso Y Cuidado página 5

Assembly
1
Attaching the table legs
Attach a leg (C) to the leg connector bracket (B) by carefully
□
guiding the bolts already in place on the table legs (C)
(each leg has two bolts) through the holes in the leg
connector bracket (B).
Add a washer (BB) and nut (DD) to the end of each bolt as
□
shown in the diagram.
Hand tighten only.
□
Repeat for the other three legs.
□
3
Tightening the nuts to the bolts
Use the hex bolt driver (GG) and hex wrench (FF) to tighten
□
all nuts (DD) and bolts (AA).
Repeat until all bolts (AA) are tight. (Do not over tighten.)
□
Cover the nuts with covers (EE).
□
Turn the table by grasping the tabletop (A) surface, but not
□
the legs (C).
DD
B
BB
C
2
Attaching the tabletop
Place the tabletop (A) up-side down on a flat, solid surface.
□
Attach a table leg (C) to the tabletop (A) by using two bolts
□
(AA) and washers (CC) as shown in the diagram.
Guide the bolts (AA) through the holes in table leg (C), into
□
the pre-drilled holes in the tabletop (A).
Hand tighten only.
□
Repeat for the other three legs.
□
AA
CC
5
Please contact 1-855-HD-HAMPTON for further assistance.
A
EE
HAMPTONBAY.COM