Aparici SCT Serie Manual Del Usuario Y Del Instalador página 10

SCxxxT_ES_EN_FR_IT_PT_ver1
MODELO
WATER
CONNECTIONS
1.- BUILDING-IN.
The water heater shall be built-in as close as possible to the outlets in order to reduce the heat loses.
The building place must be chosen considering the maximum reductions of 90º elbows in water
connections and, at the same time, make easy the substitution of the heating element.
2.- APPLIANCE WALL HANG.
Due to its particular design, the NOFER electrical water heaters could be installed in two positions as you
could see at fig-2:
1. Vertical. At this position cold water inlet pipe (F) is on the right side and hot water outlet pipe (C) on the
left side. The hydraulic safety valve supplied with the appliance must be installed at the inlet cold water
pipe (F)..
2. Horizontal with maintenance cover on left side. In this case inlet cold water pipe (F) will be placed every
time in the bottom pipe and hot water outlet pipe (C) in the upper part. The safety valve must be installed
in the bottom pipe
SC030T
G1/2'
A 470
B 575
C 282
D 415
E 204
F 249
G 140
H 380
fig.-1 – Model APARICI SCxxxT
DIMENSIONS
SC050T
G1/2'
470
860
282
415
204
470
205
380
10
SC080T SC100T
G1/2' G1/2'
570 570
900 1090
332 332
415 415
255 255
365 550
287 287
470 470