Chicco PureSteam Cooker Manual De Instrucciones página 11

Ocultar thumbs Ver también para PureSteam Cooker:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 15
During the warming up and steam cooking phases,
the jug releases hot steam that could cause burns.
The boiler, jug and all the parts that come in contact
with the steam may become very hot: always handle
the equipment with the maximum care.
- Do not open or attempt to open the boiler and jug lids
while the equipment is working.
- Always handle the blade unit very carefully: the blades
are very sharp. Always unplug the equipment from the
mains socket before touching the blades.
- To prevent the blades from becoming oxidized, always
clean and dry the blade unit thoroughly after use.
- The equipment can be opened only with special tools. To
replace the power cable, contact a qualifi ed technician
or one of Artsana S.p.A.'s authorised retailers.
- Improper mending carried out by unqualifi ed technicians
may cause damage or injuries to the user.
- Dispose of any packaging, worn accessories, and/or the
equipment according to waste regulations in force in
each country.
- This equipment complies to EC regulations and subse-
quent modifi cations.
- Keep the equipment, accessories, and all packaging (such
as plastic bags, cardboard boxes, etc.) out of children's
reach, as they may be hazardous.
This appliance is not intended for use by persons (including
children) with reduced physical, sensory or lack of experience
and knowledge unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
Children should be supervised to ensure that they do not
play with the appliance.
V. HOW TO PREPARE THE EQUIPMENT
PRIOR TO FIRST USE: Remove the equipment and its ac-
cessories from the packaging. Read carefully the instruction
booklet, recipe book and warnings, and keep them for future
reference.
All products coming into contact with foodstuffs
should always be cleaned thoroughly before and
immediately after use.
Clean all the plastic components thoroughly, except the
base (1).
To clean the boiler, prepare the equipment before use as
indicated in chapter VI. HOW TO USE THE EQUIPMENT,
and carry out a warming up cycle without placing any food,
pouring 150 ml of tap water into the boiler. Set cooking
time at 30 minutes. At the end of the cooking cycle, let the
equipment cool down, then remove the jug (8) and any
residual water. Before carrying out a cleaning cycle, check
that the jug (8) and any internal components, with the
exception of the cooking rack (7), have been removed.
WARNING! At the end of the warming up cycle, the
equipment is very hot. Always pay the maximum
attention.
VI. HOW TO USE THE EQUIPMENT
JUG
To unlock and remove the jug (8) from the base (1):
i. Move the ON/OFF switch (2) to the central position
"0"..
Note: For safety reasons, the jug (8) and lid can be
removed only if the ON/OFF switch (2) is in the
"0" position.
i. Turn the knob for locking the jug (5) in an anticlockwise
direction (diag. C1) and remove the jug (8) from its
housing, pulling it from the rear (diag. A).
To open the transparent lid of the jug (6):
i. Remove the transparent lid of the jug (6) by lifting it.
To close the transparent lid of the jug (6):
i. Fit the lid to the jug (6), taking care that the notches
coincide (diag. B).
To insert the jug and lid into the base:
i. Hold the jug from the handle and insert it into the base,
as shown in diagram A, taking care to fi tting the jug
properly in its housing (if it is positioned correctly, the jug
locks onto the raised support located on the base).
ii. Turn the locking knob (5) clockwise (diag. C2) to lock the
jug into position (8).
WARNING! For safety reasons, the cooking function
cannot be activated if:
1) the cooking rack (7) or baby food rack (12) is not fi tted
into the jug (8);
2) the transparent jug lid (6) is not placed on the jug
correctly (8);
3) the jug (8), assembled as indicated above, is not fi tted
correctly on the base (1).
BLADE UNIT
To fi x the blade unit (9) to the jug (8):
i.
Check that the blade covers (9b) are not fi xed to
the blade unit (9).
ii.
Hold the blade unit (9) carefully, and insert it into
the jug (8), paying attention to place it in a cen-
tral position on the raised metal joint located at
the bottom of the jug (8).
To remove the blade unit (9) from the jug (8):
i.
Remove the blade unit (9) from the jug by lifting
the unit (8):
WARNING!
-
The blades are very sharp: Always handle with
care. When the blade unit is not fi tted into the
jug, protect the blades with the special covers
(9b) and store the blade unit in a safe place out of
reach of children.
BEFORE OPERATING THE EQUIPMENT, ALWAYS CHECK
THAT:
- Each blade cover has been removed from the blade unit
(9b);
- The blade unit (9) is fi tted correctly into the jug (8);
- The jug (8) is locked correctly on the base (1) and the
knob for locking the jug (5) is blocked correctly in the
close position (diag.C2).
HOW TO PREPARE BABY FOOD
STEAM COOKING
Healthy Steam Cuocipappa steam cooks vegetables, fru-
it, meat, fi sh, rice, etc.
Its intense steam cooking method conveys and main-
tains a steam fl ow to the cooking rack. This is why it is
ideal in the weaning period, because it preserves food
proteins and vitamins.
The cooking process is automatically stopped when the-
re is no water left in the boiler.
To decide the correct cooking time, please refer to the
recipe book supplied.
Ensure the equipment is disconnected from the
mains and that the ON/OFF switch is in a vertical
position, on "0".
• Unscrew the lid of the boiler (4) by turning it anticlockwise
and lift it.

Publicidad

Tabla de contenido
loading

Tabla de contenido