Marathon CL030066-FD-NA Manual página 7

Installing the Refrigerator Thermometer Probe
Insert the temperature probe connection into the jack on the right-hand side
of the outdoor remote sensor.
Place the end of the probe in your desired location and place the outdoor
remote sensor in a location compatible with its temperature limitations.
Alarm set up
To enter Alarm Set Up
Hold the for 3 seconds, or until you hear a beep.
NOTE: Press and hold or to speed up the digits cycling and press
ALARM button to confirm each setting.
Default = SET HOUR
Press or to set hours.
Press 1x = SET MINUTE
Press or to set minutes.
Press 2x = EXIT ALARM SETUP MODE
NOTE: If you do not press a button for 15 seconds the clock will
automatically exit setup mode.
Alarm Activation and Deactivation
Press button to activate or deactivate the alarm. When the alarm is
activated, the alarm icon will appear on the display and the alarm time
displays for 3 seconds.
To stop the alarm, press any button, otherwise, the alarm will sounds for
approximately 2 minutes before stopping.
Steps
EN