Publicidad
Idiomas disponibles
Idiomas disponibles
EN
SYM-
SIGNAL
BOL
CAUTION
5
ENVIRONMENTALLY SAFE
BATTERY DISPOSAL
The toxic and corrosive materials below are in the
batteries used in this machine: Lithium-Ion, a toxic
material.
Discard all toxic materials in a specified manner to
prevent contamination of the environment. Before
discarding damaged or worn out Li-ion battery, contact
your local waste disposal agency, or the local
Environmental Protection Agency for information and
specific instructions. Take the batteries to a local
recycling and/or disposal center, certified for lithium-
ion disposal.
If the battery pack cracks or breaks, with or without
leaks, do not recharge it and do not use. Discard it
and replace with a new battery pack. DO NOT TRY
TO REPAIR IT! To prevent injury and risk of fire,
explosion, or electric shock, and to avoid damage to
the environment:
•
Cover the terminals of the battery with heavy-duty
adhesive tape.
•
DO NOT try to remove or destroy any of the
battery pack components.
•
DO NOT try to open the battery pack.
•
If a leak develops, the released electrolytes are
corrosive and toxic. DO NOT get the solution in the
eyes or on skin, and do not swallow it.
•
DO NOT put these batteries in your regular
household trash.
•
DO NOT incinerate.
•
DO NOT put them where they will become part of
any waste landfill or municipal solid waste stream.
•
Take them to a certified recycling or disposal
center.
SAVE THESE INSTRUCTIONS
MEANING
(Without Safety Alert Sym-
bol) Indicates a situation
that may result in property
damage.
WARNING
WARNING
English
6
INSTALLATION
Do not change or make accessories that are not
recommended by the manufacturer.
Do not put in the safety key or the battery pack until
you assemble all the parts.
6.1
UNPACK THE MACHINE
Make sure that you correctly assemble the machine
before use.
•
If the parts have damage, do not use the machine.
•
If you do not have all the parts, do not operate the
machine.
•
If the parts are damaged or missing, speak to the
service center.
1. Open the package.
2. Read the documentation in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and package in compliance with
local regulations.
6.2
UNFOLD THE LOWER HANDLE
Figure 2.
1. Pull and turn the handle knobs 90°.
2. Unfold the lower handle.
3. Line up the handle knobs in one of the three
positions on the brackets.
4. Turn the handle knobs 90° until they engage the
holes in the brackets.
Make sure that the two handle knobs are in the same
position.
Do not make damage to the cables when you fold or
unfold the handle.
6.3
INSTALL THE UPPER HANDLE
Figure 3.
8
WARNING
WARNING
WARNING
WARNING
NOTE
WARNING
Publicidad
