GB/IE
WARNING!
!
Risk of injury!
Not suitable for children
under the age of 8! There is a
8
risk of injury!
- Children from the age of 8, as well as people with
impaired physical, sensory or mental capabilities
or with a lack of experience and knowledge, must
be supervised when using the product and/or be
instructed regarding the safe use of the product
and understand the resulting dangers.
- Children are not allowed to play with the product.
- Maintenance and/or cleaning of the product is
not allowed to be performed by children without
supervision.
Observe national regulations!
- Observe the applicable national requirements and
regulations for the use and disposal of the product.
Pay attention to ambient conditions!
- The product is not allowed to be used in tempera-
tures above 40°C and/or below -10°C.
WARNING!
!
Risk of injury!
Do not use in an explosive environ-
ment! There is a risk of injury!
- The product is not allowed to be used in
an explosive (Ex) environment. The product is not
approved for an environment, in which flammable
liquids, gases or dust are present.
WARNING!
!
Risk of injury!
A defective product is not allowed to be
used! There is a risk of injury!
- Do not use the product in the case of malfunctions,
damage or defects.
- The LEDs are not replaceable. If the LEDs are de-
fective, the product must be disposed of.
- Significant danger can occur for the user in the
case of improper repairs.
WARNING!
!
Risk of injury!
The product is not allowed to be ma-
nipulated! There is a risk of injury
from electric shock!
- The casing must not be opened and the product
must not be manipulated/modified under any
10
circumstances. Manipulations/modifications can
cause danger to life from electric shock. Manipu-
lations/modifications are prohibited for approval
reasons (CE).
- Check voltages! Make sure that the existing
mains voltage corresponds to the specification on
the rating place. Failure to comply can lead to ex-
cessive heat development.
- The product must not be covered up during use.
- Never touch the power plug with wet hands, if it is
in operation.
CAUTION!
!
Danger of overheating!
Remove packaging prior to use.
Start-up
1. Remove all packaging materials.
2. Check whether all parts are available and undamaged.
If this is not the case, notify the specified service
address.
Product set up
1. Set up the product
1
in an appropriate place.
WARNING!
!
Risk of injury!
The product may not be placed on
damp or wet surfaces or in water.
There is a risk of electric shock!
- Only place the product
1
on dry surfaces.
- Make sure that the power supply cable cannot be
damaged by sharp edges or hot objects.
- Unplug the power cord
2b
from the wall outlet
when the product
1
is not in use.
- The surface should be even, so that the product
cannot fall over.
- The place should have sufficient free space around
the product
1
.
- We recommend placing a protective blanket un-
der the product
1
. Sensitive surfaces could be-
come scratched by the product
1
.
NOTE!
The operation/connection module
3
is located at
the bottom left of the product
1
on the rear side.
2. Insert the connector plug
2a
of the mains power
adapter
2
into the input socket
4
on the opera-
tion/connection module
3
, see Fig. B1.
3. Insert the mains plug
2b
adapter
2
into a correctly installed wall outlet,
see Fig. B2.
NOTE!
The wall socket should be easily accessible so that the mains
power adapter can be pulled out quickly if necessary.
Only applies for 365148-21-A-EU:
Place the figures
6a
with the magnetic foot and felt
gliders on the ice rink
7
. As soon as you approach
one of the magnets located under the ice rink
a figure, the figure will be magnetically attracted.
Then place the figure down at this point.
The product
1
is now ready to use.
Use
On/off switching, activate moving parts,
music and timer (C)
You can switch the following modes with the switch
5
on the operation/connection module
ON1: Light + music + motion + timer on
OFF: switched off
ON2: Light + motion + timer on
Timer function
The product
1
is equipped with a timer function.
When one of the "ON1" or "ON2" modes is se-
lected, the timer function is turned on. If the timer is
on, the product
1
will automatically switch off after
6 hours. After another 18 hours, the product
automatically switch back on. As long as the switch
5
is left in the "ON1" or "ON2" position, this daily
rhythm will be repeated.
NOTE!
1
- The product
1
offers 8 Christmas melodies. If the
"ON1" mode is selected, these 8 melodies are
played back one after the other in a continuous loop.
- No direct selection of melodies can be made.
- The speaker is located on the bottom side of the
product
1
. Therefore, do not place the product
on a surface that is too soft. The sound will other-
wise be too muffled.
NOTE!
Risk of material damage
- Ensure that the moving parts
6
product
1
are not restricted or impeded in their range
of movement. There is a risk of material damage.
of the mains power
- Remove any objects in the movement radii before
start-up.
Cleaning & care instructions
WARNING!
!
Risk of injury!
Before cleaning, you must discon-
nect the power plug. There is a risk
of electric shock!
- clean only with a feather duster
- contaminants may be blown away
7
with
- do not use any strong detergents and/or chemicals
- do not immerse in water
- store in a cool, dry place and protected from UV light
Only applies for 365148-21-A-EU:
- clean the felt gliders of the figures
with a damp, lint-free cloth
- Storage: wrap the figures
paper or cloth and place them with the product
3
:
Disposal
Disposal of the packaging
The packaging and operating instruc-
tions are made of 100 % environmen-
tally friendly materials, which you may
dispose of at local recycling centres.
Disposal of the product
The product may not be disposed of with nor-
1
will
mal household waste. Please find out about
disposal options for the product from your lo-
cal authority or town administration.
1
(Fig. A) of the
/
6a
GB/IE
6a
regularly
6a
individually in a soft
11