Lacme CLOS B100 Instrucciones De Empleo página 5

Les Pelouses
Route du Lude
72200 LA FLECHE
Tél : +33 (0)2 43 48 20 81
Fax : +33 (0)2 43 45 24 25
www.lacme.com
You have purchased a fence energizer Lacmé. We thank you for your trust.
It is a fencing energizer with a mixed power supply (dual). Its power can be supplied equally well by :
- a 12 V wet cell battery (lead, in a suitable format)
- a 12 V wet cell battery (lead, in a suitable format) and the mains adaptor (optional)
- the mains adaptor (optional) exclusively supplied by LACME
Different power levels and options depending on the model are described in this notice.
This logo confirms that you can power your energiser with an AC adapter.
Only the mains adaptor exclusively supplied by LACME
For safety reasons, this energizer must never be connected to any other mains adaptor. The mains adaptor
supplied by LACME must not be used on an energizer from another manufacturer, or on any old/other LACME
model not designed for this purpose (if in doubt, refer to the guide provided with your energizer).
The technology called "low impedance" allows the fence to remain effective even if losses occur grass touching the
wire,broken insulators...).
This energizer conforms to International Safety Standards and is approved by the French Ministry of Agriculture. It
is supplied with a high voltage wire connection and two small earth/grounds rod connexion. Ground stakes must be
added for less conducive ground.
FUNCTIONS :
A power output control adjusts the output power according to requirements (depending on the type of
animal, length of the fencing, insulation, humidity, etc.), and in particular enables power consumption to be
reduced as soon as the animal training stage is completed. Each of the ten graduations represents approximately
10% of the energy range that is covered by the power output control.
On the front panel, a multifunction check LED indicates correct operation during each pulse.
This 3-colour indicator light (green, orange, red) is also used to visually check the discharge status of the power
supply (press briefly), except CLOS B100. Testing can also be undertaken at a close distance with a BIP
CONTROL pocket tester.
Always recharge a wet cell battery that is in the red zone as soon as possible. For a battery, the exchange can
wait until it is fully discharged.
When the power supplied to the energizer becomes too low, ACCU PROTECT automatically switches the device
into ECO 1/5 mode.
Clos B200-B300 - An additional and economical operating mode "ECO 1/5",
button for 4 seconds. An orange light will flicker briefly on the display lamp in order to confirm this mode change.
From this moment on, the energizer will repeat a 5 pulse cycle : the power of the first pulse is determined by the
output control (green display light), the remaining four pulses are of a reduced power level (orange display light).
To return to the 'normal' operational mode, either repeat this same process or switch the device off.
CLOS
B100, B200, B300
.
(Réf. : 624.000)
is optionally allowed on this energizer.
(Réf. : 624.000)
5
, can be activated by pushing the
EN