Control Panel - DSR INC100 Manual Del Usuario

11. CONTROL PANEL

LED (yellow/orange) – Lights when the battery is properly connected.
LED (yellow/orange) – Lights when output begins; turns off when maximum voltage
is reached.
LED (green) – Lights when maximum voltage is reached.
and (UP and DOWN) Buttons
Use these buttons to set the voltage needed for FLASH REPROGRAM.
START/STOP Button – This starts and stops all modes.
Digital Display – Gives a digital indication of voltage or amperes, depending on the
display function chosen.
Display Button – Press to set the function of the digital display to one of the following:
• VOLTS (Voltmeter)
The voltmeter indicates the voltage at the load/battery terminals.
If the reading is 12.8 volts or more when output is off, the battery is charged.
• AMPS (Ammeter)
The ammeter indicates the amount of current, measured in amps, that is being drawn by
the load/battery (± 2 amps).
Mode Button – Use this button to select between SERVICE and BOOST modes.
See Operating Instructions for details of these modes.
Flash Reprogram Button – Press to select the FLASH REPROGRAM function.
See Operating Instructions for details of this function.
12. OPERATING INSTRUCTIONS
Application Information
This unit can be used to support 12V batteries with rated capacities of 12 Ah to 111 Ah.
Unit Operation
NOTE: Once Service, Boost or Flash Reprogram has started, the buttons will not work until you
turn off the output, with the exception of the START/STOP button. When the display shows ,
no buttons will work for five seconds as the unit automatically goes back to the default settings.
Service Mode
Use to prevent the battery from being discharged during service and in the showroom.
1. Connect the battery and AC power, following the precautions listed in sections 5, 6 and 7.
2. Set the MODE to SERVICE.
3. The VOLTS LED will light, and the display will show battery voltage.
4. Press the START/STOP button. The yellow/orange
5. The green
maximum voltage is reached.
NOTE: Maximum voltage for Service Mode is 13.5V.
LED will light and the yellow/orange
LED will light.
LED will turn off when the
• 6 •