Black and Decker BDXPA0004 Manual De Instrucciones página 4

Indoor Wireless Remote Control Outlets
Danger of explosion if battery is incorrectly replaced. When replacing battery,
WARNING:
replace it with the same or equivalent type CR2032. Observe correct polarity (+ and –) when
replacing batteries. Do not store or carry batteries so that metal objects can contact exposed
battery terminals.
DO NOT INGEST BATTERY; CHEMICAL BURN HAZARD. This product contains
DANGER:
a coin/button cell battery. If the coin/button cell battery is swallowed, it can cause severe internal
burns in just 2 hours and can lead to death.
Keep new and used batteries away from children. If the battery compartment does not close
securely, stop using the product and keep it away from children.
If you think batteries might have been swallowed or placed inside any part of the body, seek
immediate medical attention.
Please do not plug anything in receiver that should not be left unattended.
WARNING:
Note: Regardless of whether the light is ON or OFF, when random mode is selected the light
will turn OFF.
1
2
3
ON -1- OFF
ON -2- OFF
ON -3- OFF
-4-
ON OFF
4H 1H
3H 2H
C. If successfully paired, but you wish to unpair and tie the outlet to another button on the remote,
long-press the receiver button on the left side of the outlet [shown in figure under step 3] until
the indicator light starts flashing [approximately 4 seconds]. You may then press any new ON
or OFF button on the remote control. When the new pairing is successful, the indicator light on
the outlet will stop flashing.
1. Step A: Locate the battery compartment on the back of
the remote. Push down and away to slide the
compartment cover off.
Step B: Remove the plastic battery tab from the battery
compartment in the back of the remote control to
activate the pre-installed battery.
Step C: Slide the compartment cover on the remote and
click securely into place. Your remote is now
ready to use.
2. Plug the receiver into a standard AC electrical wall
socket. Plug the appliance into the receiver outlet.
3. Before using the outlet with remote control, please pair
as follows:
A. Plug the outlet into the wall socket. When the
receiver indicator light begins flashing, press any ON
or OFF button to pair the outlet to a corresponding
number on the remote control.
B. When first using and pairing outlets to the remote
control, please plug-in and pair one outlet at a time.
4