FCC Statement
WARNING: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for help.
Company Name: Eurofase Inc.
Company address: 60 Industrial Parkway, Unit 802, Cheektowaga, NY 14227-2713
Telephone Number: 905.695.2055 x 259
Care and Cleaning
Troubleshooting
P P r r o o b b l l em
em
The fixture will not light.
The fuse blows or the circuit breaker
trips when the light is turned on.
P P o o s s si sib b l l e e C C a a u u se se
The LED is burned out.
The power is off.
There is a faulty wire connection.
There is a faulty switch.
There are crossed wires or power wire is
grounding out.
C C o o r r r r e e ct cti i v v e e A A c c t t i i on on
Replace the fixture.
□
Make sure power supply is on.
□
Check wiring.
□
Test or replace the switch.
□
Check the wire connections.
□
Contact a qualified electrician or call the
□
Customer Service Team at 1-833-695-2045.
6