RACCEWAY E-JLG Manual De Usuario página 10

NOT enclose it in a storage compartment or other unventilated space when charging.
The charger is designed for indoor, dry-area use only.
WARNING! DO NOT expose charger to water.
If absolutely necessary, you could place the charger on the floorboard and drape the
bike with its cover allowing for sufficient ventilation. You do so at your own risk.
Connecting the Charger
Make sure the bike's circuit breaker is ON.
To charge the battery pack, the bike's main circuit breaker must be ON. If the breaker
is off, the charger will only seem like it is charging the battery.
Understanding The Charger's Indicator Lights
The supplied Electric Vehicle charger is fully automatic and has two indica¬tors
lights to tell you what is happening. One red LED indicates that it is connected to
power, while the second LED changes between red, to indicate "charging" and green,
to indicate "full".
Normal charger/indicator behaviour is as follows:
When the charger is connected to AC power but not plugged into
the bike's charge socket, you will see 1 red and 1 green light.
When the charger is then connected to a bike that needs charging, it will enter the
"bulk-charge" mode and both lights will appear red and the fan will run.
When a full charge is reached, it goes into "float mode" and the lights will return to 1
red, 1 green.
NOTE: Because the un-connected indicator state matches the fully-charged state,
always verify that charging has begun by looking for the 2 red lights and listening for
the fan. If you are not sure if the bike even needs charging, just ride the bike a for a
bit or rev the motor (with the bike on the main stand and rear wheel in the air) to
make it start the charge cycle.
NOTE: If you should happen to connect the charger only to the bike but not to AC
power, only one red LED will light. This light is being powered by the battery pack and
9