Buffalo CU626 Manual De Instrucciones página 6

EN
Scraping
After each use, scrape the appliance with a soft plastic or wooden scraper to remove excess fat and food.
If there is an accumulation of burned fat or food, the cooking surface should be thoroughly scoured and
re-seasoned.
Caution:
It is vital that the cooking surface is re-seasoned after scouring.
Do not use steel wool as it may leave shards that could contaminate food.
Waste Tray
This appliance is featured with a waste tray to collect any liquid or fats that run off during cooking.
At least once a day, remove and empty the waste tray before washing with warm soapy water. Do not
allow the tray to overfill.
WARNING: DO NOT remove the tray during or immediately after use as the contents are
still hot.
Troubleshooting
A qualified technician must carry out repairs if required.
Fault Probable Cause
The appliance is Unit is not switched on
not working
Plug or lead is damaged
Fuse in the plug has blown
Mains power supply fault
Thermal cut-out switch has
been activated
HEAT indicator Faulty element
light comes on but
Faulty thermostat
appliance does not
Thermostat set incorrectly
heat up
Surface flaking Build up of carbonised food
debris
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage
CU626
220-240V~,
50/60Hz
CU627
6
CU626-CU627_ML_A5_v1_20240207.indb 6
Solution
Check the unit is plugged in correctly and switched on
Replace plug or lead
Replace the fuse
Check mains power supply
Check the machine is safe with no obvious damage
and then press the re-set switch on rear of unit
Consult a qualified technician
Consult a qualified technician
Check thermostat
Refer to "Cleaning, Care & Maintenance" section
Cooking surface
Power
size (mm)
2900W 520 x 330
2900W 740 x 330
Dimensions
Weight
(H x W x D) (mm)
200 x 523 x 415
200 x 743 x 415 35.4kg
25kg
2024/2/7 14:35:55