Installing The Instrument - Quick RDS 1520 Manual Del Usuario

CHARACTERISTICS AND INSTALLATION
GB
RDS 1520
The RDS 1520 remote display allows status of the SBC ADV PLUS medium and high power battery chargers to be
monitored through the CAN BUS interface.
INSTALLATION
BEFORE USING THE INSTRUMENT CAREFULLY READ THIS USER'S MANUAL. IN CASE OF DOUBT
CONTACT THE "QUICK
F
In case of discordance or errors in translation between the translated version and the original text in
the Italian language, reference will be made to the Italian or English text.
F
This device was designed and constructed for use on recreational crafts.
Other forms of use are not permitted without written authorization from the company Quick
®
The Quick RDS 1520 remote control panel has been designed for the purposes and tasks outlined in this User's
®
Manual. Quick shall not be held responsible for any direct or indirect property damage or personal injury
caused by inappropriate or unintended use of the equipment, erroneous installation or any errors that may be
present in this manual.
THE WARRANTY SHALL BE VOID IF THE INSTRUMENT IS TAMPERED WITH OR ALTERED BY NON
AUTHORISED PERSONNEL.
THE PACKAGE CONTAINS: RDS 1520 - drilling template - connecting cable - user's manual - conditions of warranty.

INSTALLING THE INSTRUMENT

The typical installation procedure is described herein. Needless to say, it is not possible to describe a proce-
dure applicable for all situations that may be encountered. Adapt this procedure to satisfy your own personal
requirements.
Locate the most suitable position to house the instrument following the recommendations given below:
• The instrument should be installed in a place where it can be easily read by the operator.
• Select a clean, smooth and flat area.
• Access from the rear must be available for installation and maintenance purposes.
• Leave enough space free behind the installation to conveniently fit the back of the instrument and the con-
nectors.
• The back of the instrument must be protected against contact with water and moisture.
• Pay careful attention when drilling the panel or parts of the boat. This hole should not weaken or break/crack
the boat's structure.
The instrument meets EMC standards (electromagnetic compatibility) however correct installation is fundamen-
tal in order not to compromise its performance as well as operation of the instruments found nearby.
For this reason, the instrument should be at least:
• 25 cm away from the compass.
• 50 cm away from any radio receivers.
• 1 m away from any radio transmitters (except for SSB).
• 2 m away from any SSB radio transmitters.
• 2 m away from radar beams.
10
®
" SUPPLIER OR AFTER SALES SERVICE DEPARTMENT.
®
.
RDS 1520 - REV003A