Publicidad
Idiomas disponibles
Idiomas disponibles
MOD-WIFI
DESCRIPTION:
communication module cooperating with
the CPX300W alarm control panel, powered
directly
from
motherboard.
The
connecting the CPX300W control panel to a
wireless WLAN Wi-Fi network ,available at
the place of installation.
MODULE INSTALLATION:
the possibility of damage to the connector) into the dedicated connector on the CPX300W motherboard
(labelled "ETH / Wi-Fi"- see Fig.2, item 1) and then screwed with a screw attached to the set (Fig. 2 item 2).
NOTE! All installation activities should be carried out with power disconnected.
The SMD antenna is build-in the PCB, it means the module cannot be mounted in a metal housing!
Fig. 2. View of CPX300W board with installed module.
For more information, refer to the installation manual for CPX300W and EBS Config 2.0 Programming manual.
EBS Sp. z o. o.
ul. Bronisława Czecha 59, 04-555 Warsaw, POLAND
Technical support: phone +48 22 51 88 477, e-mail: support@ebssmart.com
www.ebssmart.com
AVA PRO Wireless communication module Wi-Fi
WLAN
wireless
the
control
panel
module
enables
The module should be inserted at an angle of approximately 30° (to minimize
Fig. 1. View of the module PCB with descriptions.
1
Widok
płyty
CPX30
0W z
wmon
towan
ym
moduł
em.
SPECIFICATION:
Type of antenna
Chipset Wi-Fi
Supported frequency band
Supported standards
Safety standard
Encryption
Support for WPS
Dimensions
- Connector for installation of the module,
- WPS button, that allows connecting a device to a
protected Wi-Fi network without the need to
enter network name and password,
- SMD antenna,
- Mounting hole for the screw.
WPS SIGNALING:
adding the control panel to the Wi-Fi
network should be started by pressing
2
WPS on the router. Then, after
Widok
pressing the WPS button on the
płyty
module (Fig. 1, point 2), the ETH / Wi-Fi
CPX300
LED will start blinking rapidly. This is a
W z
sign that the device has started
wmont
searching for the network. When
owany
connected, the LED will blink twice a
m
second for about a minute, and then it
modułe
will go back to the normal mode. If the
m.
connection is unsuccessful, the LED will
immediately
operating mode.
SMD (built-in)
ESP8266EX
2.4GHz
802.11 b/g/n
WPA/WPA2
WEP/TKIP/AES
YES
36.5 x 27 mm
The process of
switch
to
normal
MOD-WIFI_manual_PL_EN_ES_PT_v1.2
Publicidad
