Publicidad
Idiomas disponibles
Idiomas disponibles
Drain Tube
A. ⁷⁄₈ " adjustable hose clamp
B. Drain tube (ice bin to drain pump)
5. Install vent tube (⁵⁄₁₆" ID x 32" [81 cm]) to drain pump reservoir
vent. Use one ⁵⁄₈" small adjustable clamp, supplied. See
"Parts Locations" illustration.
NOTE: Do not install household drain tube at this time.
Parts Locations
G
A. Vent tube
B. ⁵⁄₈ " hose clamp
C. Drain pump discharge tube
D. Drain pump
6. Remove power cord clamp and ground screw attached to ice
maker power cord, which is mounted to the unit base. See
"Parts Locations" illustration.
NOTE: Clamp and screw will be reused.
7. Slide drain pump into the ice maker base on the right side.
The pump mounting tab should slip into the rectangular slot
in the ice maker base. It will be necessary to tip the pump
slightly to slip into the slot. See "Drain Pump Mounting Tab
Slot" illustration.
6
All manuals and user guides at all-guides.com
A
B
C
D
C. ⁷⁄₈ " adjustable hose clamp
D. Drain pump reservoir inlet
A
B
C
D
E
F
E. Ice maker unit power cord
F. #8-32 x ³⁄₈ " pump mounting screws
G. Drain pump power cord, clamp
and screw
Drain Pump Mounting Tab Slot
A. Mounting tab slot
Drain Pump Installed
A. Drain pump installed
8. Align the 2 screw holes at the rear of the pump. Use two
#8-32 x ³⁄₈" screws, supplied. See "Parts Locations"
illustration.
9. Connect drain tube to ice maker bin outlet (⁵⁄₈" ID), using ⁷⁄₈"
adjustable clamp, supplied. See "Drain Tube" illustration.
10. Coil ice maker power cord into a 4" (10.2 cm) diameter coil.
Wrap electrical tape around the power cord in several places
to keep the cord in a coil. Locate coiled power cord between
the drain pump and side of enclosure and plug into the
receptacle of the drain pump. See "Parts Locations"
illustration.
11. Attach the drain pump power cord to ice maker unit base with
clamp and screw (removed in Step 6) that was used to attach
ice maker power cord. See "Parts Locations" illustration.
12. Place new rear panel (small one for 15" ice makers, large one
for 18") against the back of the ice maker. Route the vent
tube and drain pump discharge tube through cutouts in the
rear panel.
13. Secure rear panel with original screws. See "Rear Panel"
illustration.
14. Secure vent tube to back of ice maker using 3 clamps and
three #8-32 x ³⁄₈" screws, supplied. See "Vent Tube"
illustration.
A
A
Publicidad
