Publicidad
10
DVS EN54
3. Standard accessories
Cable Clamp Cover
Yoke Bracket (Supplied with fixings)
Bracket Clamp Tool
4. Installation guidelines
1. Fix the yoke bracket to the
2. Feed the speaker cable through
surface using a suitable
the cable clamp cover then
fixing method.
connect the Euro-type plug
to the wires, observing the
correct polarity.
5. Connect the Euro-type plug
6. The DVS 4T (EN54)/-WH
then replace the cable clamp
models are fitted with
cover to ensure the speaker
30 W transformers.
is sealed.
The speaker is supplied
in low impedance mode.
never connect the speaker to a
70/100 volt amplifier while it is
set for low impedance.
Quick Start Guide
3. For connection to the
4. Offer the speaker up to the
loudspeaker, use Pins 1 (+)
bracket and attach using
and 2 (-). Pins 3 (-) and 4 (+)
the screw caps then tighten
are in parallel for connection
using the bracket clamp
to additional speakers in a
tool provided.
distributed line.
7. The DVS 6T (EN54)/-WH
models are fitted with
60 W transformers.
The speaker is supplied
in low impedance mode.
never connect the speaker to a
70/100 volt amplifier while it is
set for low impedance.
11
Publicidad
