Publicidad
Idiomas disponibles
Idiomas disponibles
7. Wipe grinding bowl, cover, base and other parts with a slightly damp cloth
or sponge. Dry all parts thoroughly before reassembling.
8. To replace grinding assembly, set inside grinding
bowl and twist slightly to the left until it falls into
place. Grasp lock and release knob and turn
counterclockwise to lock assembly (F). You will hear
a series of clicks as the selection dial rotates, and
then a distinct pop once the assembly is locked in
place.
Important: Do not immerse grinding bowl, base or plug
in liquid or under running water.
F
9. Never use harsh detergents, abrasive cleansers or scouring pads to clean
any part.
10. Use built-in cord wrap on underside of unit to store
cord (G).
G
7
Downloaded from
www.Manualslib.com
manuals search engine
TROUBLESHOOTING
PROBLEM
POSSIBLE C USE
Grinder stops working.
Ground coffee container has
disengaged.
There are too many beans in
grinding bowl.
Coffee tastes rancid.
Grinder has buildup of coffee
grounds.
Coffee tastes like nuts or spices.
Grinder has been used for
other grinding operations.
Grinder will not start.
Grinder cover is not
completely closed.
Ground coffee container is
not properly placed. Cover
is not on the ground coffee
container. Outlet is not
working.
The ground fineness selector is
The grinding blade is not
not working.
correctly positioned.
SOLUTION
Make sure discharge
chute is clean and
free of coffee grinds;
a buildup of coffee
grounds will cause
ground coffee container
to slip forward. Unplug
appliance and remove
some of the beans from
grinding bowl.
Oil in coffee beans will
become rancid if left
in grinder. Make sure
there are no beans left in
grinder. Clean discharge
chute and the ground
coffee container after
each use..
Grinder will share
flavors; purchase another
grinder for spices and
nuts.
Grinder cover snaps into
place when completely
closed.
Make sure cover on
ground coffee container
is in place; push ground
coffee container securely
back in base so that front
is flush with base of the
base.
Check to make sure
outlet is working.
Remove grinding blade
and clean following
directions in C RE ND
CLE NING. Reattach
grinding blade making
sure it is fully integrated.
8
Publicidad
