SANNOVER BYPSO VERTICAL Manual Del Usuario página 22

Instruction
Preparation before use
1.
Filling with water: Open the water mixing valve, lift the mixing valve handle, turn it
clockwise to the highest point of the high-temperature zone, then open the water inlet valve. The
water is then sent to the inner tank until the hot water outlet is normal. At this time, it indicates
that the inner tank has been filled with water, close the water mixing valve and turn the handle
counterclockwise to the lowest point of the low-temperature zone.
When the water temperature reaches the programmed temperature, the heating indicator on the
panel turns green and the water heater automatically stops heating. The water temperature has
reached the set temperature and enters the heat conservation state. At this time, the user can
activate the mixing valve switch and slowly switch from the low-temperature zone to the heat
conservation state. Turn the mixer tap handle in the high-temperature area, carefully test the water
temperature with your hands, adjust it to the water temperature you need, then you can use it with
confidence. When the water temperature falls to a certain level, the water heater automatically warms
up.
Note: the water temperature may be slightly higher, please test the water temperature before use, do
not test the water temperature on the human body, in order to avoid burns!
Description of functions
1. Set the water temperature.
Turn the dial clockwise to increase the temperature and counterclockwise to decrease it. The
temperature setting range is 30°C to 75°C. When you turn the knob to the lowest position, return to the
initial position and the electric water heater no longer produces heat.
2. Heating
Heating: When the water temperature reaches the set temperature, the heating stops and the heating
indicator turns off
Open
Closed
temperature
Low
High
temperature
EN