Betzold Timello Instrucciones página 5

EN IMPORTANT – PLEASE READ INSTRUCTIONS CAREFULLY AND KEEP FOR FUTURE REFERENCE.
Main feature
1. LCD count-down timer.
2. 4 digits display showing minute ("M" mark) and
second ("S" mark).
3. Timing range: 1-99'59"
4. Buzzing output when timer counts down at
last second.
5. Timer memory recall function.
6. [MIN], [SEC] individual buttons for minute and
second setting.
7. Clockwise function.
Product shows
SWITCH
Timing setting
1. Press [MIN] button to advance minute digits
(deep sound can be heard). Press and hold
[MIN] button for speed setting.
2. Press [SEC] button to advance second digits
(deep sound can be heard). Press and hold
[SEC] button for speed setting.
3. Press [MIN] and [SEC] button at the same time
to reset timer to zero.
Timer START/STOP
1. After time setting is ready, press [Start/Stop]
button once and timer will start to count down.
"M" and "S" marks will flash when timer is
counting.
2. Press [Start/Stop] button once and timer will
stop. "M" and "S" marks will stop flashing.
3. Press [Start/Stop] button once and timer will
resume counting again.
4. After buzzing stop, press [Start/Stop] button
once can return to last setting time.
Art.-Nr. 760945
Timer Buzzer Alarm
1. When timer counts down to 00M00S, timer
2. Buzzing can be stopped by pressing any button.
Timer Memory Recall
After buzzing stops, press [Start/Stop] button once
to recall pre-set time and timer will count down
for another lap.
Clockwise Function
Press [MIN] and [SEC] button at the same time,
when display shows 00M00S.
Press [START/STOP] button once going to clockwise
CLIP
Battery Replacement
Follow the arrow direction to open the battery co-
ver at back side of timer.
MAGNET
Remove old battery, insert a new micro battery
type AAA (LR03) as indicated by the polarity sym-
BATTERY
bols (+ & -) marked and close battery cover.
COVER
Clip Attachement
The timer can clip on thin board or shirt pocket,
using the plastic clip at rear of timer. The timer can
attack to iron or steel surface, using the magnet at
rear of timer. The timer can stand on table surface,
flip out the metal stand bar at rear of timer.
Timer Switch ON/OFF
When not using the timer, press the switch to off.
Timer can shutdown, enter the power saving mode.
5
buzzing will sound for 30 seconds.
© Arnulf Betzold GmbH