FAAC TM2 45 PPR Manual De Instrucciones página 26

SPECIAL FUNCTIONS
TEMPORARILY MEMORISING A REMOTE CONTROL
This function allows a remote control to be memorised temporarily, for example in
order to allow the limit stops to be set during assembly at the factory. The actual
remote control can be memorised at a later stage using the appropriate command
sequence (see "MEMORISING THE FIRST REMOTE CONTROL").
The following operations can only be carried out when the motor is brand new, or
after the memory has been completely erased (see "TOTAL DELETION OF REMOTE
CONTROLS"). To ensure that temporary programming is used only during installa-
tion or adjustment, and not for everyday use, the motor only allows the following
operations to be carried out within the time limits described.
Power up the motor, make sure that there are no other powered motors and with
empty memories within the range of the remote control.
Within 30 seconds of switching it on, press buttons B and C simultaneously, until
the motor issues a confirmation signal.
The remote control will be memorised for 5 minutes, while the motor is powered.
After 5 minutes have elapsed, or if you switch off the power to the motor, the remote
control will be deleted.
T1: First remote control to be memorised
+
B C
T1
TM2 PPR 26 A4518_6G85_Rev.A