Publicidad
Idiomas disponibles
Idiomas disponibles
2
.
z Digital Cordless Optical Mouse f US
ID Setting
Each cordless mouse has to get an IP from a specific receiver before
start working, it also called ID Setting. The ID-Setting helps to protect
against interference from other cordless mouse in the same environment
Please follow below steps to complete the necessary ID-Setting
process for your cordless mouse and USB dongle receiver.
t.Make sure the mouse hardware installation is completed.
2. Turn your cordless mouse on.
3. Turn your Notebook or PC computer on.
4. Plug the USB dongle receiver into your computer's USB port.
5. Waiting for the USB plug and play initialization completed, and the dongle
receiver LED will light flush.
6. Move your cordless mouse close to the USB dongle receiver within
30 cm, then click the mouse left button to start ID-Paring process.
(It will take about 4~8 seconds waiting time)
7.Once the ID-Setting process is completed, the receiver LED will tight
off. The receiver LED will light on again when cordless mouse is working.
8. If the mouse doesn't work properly (the receiver LED still light flush),
please remove the USB dongle receiver from computer's USB port,
then repeat do step 4 to step 7 again.
9. Enjoy using your cordless mouse.
Publicidad
