Publicidad
Idiomas disponibles
Idiomas disponibles
prevent any damage to the motor of the fan or controller (if installed).
14. Do not insert anything into the fan blades whilst they are spinning. This will damage the blades
and upset the balance of the fan causing the unit to wobble.
15. After the fan is completely installed make sure that all base and fan blade fixings are secured and
tightened to prevent any problems.
16. Because of the fan's natural movement, some connections may loosen. Check the support
connections, brackets and blade attachments twice a year to make sure they remain secured. If any
are loose, tighten.
17. This product has tie type "Y". If the cord is damaged, it must be replaced by the manufacturer or
its service agent or qualified personnel to avoid risk.
18. Danger: You should not repair the appliance by yourself. It must be done just by qualified
specialists. Only original spare parts may be used for repair.
19. To unplug before to touch the sockets.
20. Wipe with a dry cloth moistened with soap and water. Dry thoroughly. Unplug the power before
cleaning. Do not allow water inside.
REPARATION
Unpack your ceiling fan carefully, then remove all parts and components, and lay on a cloth or soft
surface to avoid damage. Do not lay the motor housing on its side, the housing may get damaged.
Before commencing installation, check that all parts are included.
NB: You may need to remove all foam packaging material to ensure there are no missing components
1. Make sure that the installation site will not allow the rotating fan blades to come into contact with
any object and that there is a minimum clearance of 150mm (6") from the blade tip to the wall or
ceiling. Please note that the bigger this clearance is the better the airflow from your fan will be.
DO NOT use outdoors. Installing the fan in a position where it could be exposed to water or moisture
is dangerous.
Publicidad
