Publicidad
Idiomas disponibles
Idiomas disponibles
INSTALLING THE BACK
1.
Place bath seat on its side on a flat working surface.
2.
Locate the channel guides (4 each) on underside of seat. Align
backrest support tubes with channel guides.
3.
Slide backrest seat support tubes through channel guides until seat
support tube push buttons protrude fully through channel guide holes.
NOTE: Ensure seat support tube buttons protrude fully through channel
guide holes.
CAUTION: Backrest is not designed to support the full weight of the user.
ADJUSTING LEG HEIGHT
Legs are already installed on the bath seat.
To adjust leg height:
1.
Press push button and slide leg extension up or down to desired
adjustment hole.
2.
Ensure push button fully protrudes through the leg adjustment holes of
the leg extension.
NOTE: An audible "click" will be heard.
3.
Repeat STEPS 1 and 2 for the other three legs.
NOTE: Ensure all four legs are adjusted to the same height and that all
height adjustment buttons protrude fully through the adjustment holes
before use.
(ONLY FOR 7939A)
Publicidad
