DeWalt D259804-CA Guia De Inicio Rapido

English
BREAKER TRUCK
D259804
For Use with D25980, D25960

WARNING: Improper operation or maintenance of this product could result in serious
injury and property damage. Read and understand all warnings and operating
instructions in the pavement breaker's instruction manual before operating or
performing maintenance on this equipment.

WARNING: Turn off the pavement breaker and unplug from the power source before
making any adjustments or removing or installing attachments or accessories.
CONTENTS (FIG. A)
1 Handle
2 Cord clip
3 Latch
4 1" (25.4 mm) chisel bit (1)
5 3" (76.2 mm) chisel bit (1)
Usage and Transport (Fig. A–D)

WARNING: Tip hazard. Be sure truck is secure prior to loading or unloading the breaker.
To load and remove breaker on cart:
1. Lift latch 3 .
2. Align tool holder with breaker alignment pin
NOTE: Bit retainer must be in the up locked positon.
3. Lower latch over breaker.
4. Wrap cord around lower half of handle and secure end with cord clip
5. To remove follow these steps in reverse order.
Transporting

WARNING: Risk of unsafe operation. Ensure proper footing and use caution when rolling
hammer truck so it does not tip or cause loss of balance.

WARNING: Risk of unsafe operation. Do not exceed load limit of 110 lbs. (50 kg).
Personal injury may result. Refer to the warning label

CAUTION: Risk of unsafe operation. Do not transport unsecured tool. Personal injury
may result.

CAUTION: When transporting, be sure all chisels are secured in chisel storage by
tightening the storage knobs
1. With pavement breaker secured, grasp handle
can be rolled on the tires.
2. When location is reached, slowly lower hammer truck to rest on base plate
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286 (DEC16) Part No. N510361 Copyright © 2016 D
e
The following are trademarks for one or more De WALT power tools: the yellow and black color scheme; the "D" shaped air intake grill; the array of pyramids on the handgrip; the kit box
configuration; and the array of lozenge-shaped humps on the surface of the tool.
Final page size: 8.5x11
6 Bull point chisel bit (1)
7 Chisel storage
8 Breaker alignment pin
9 Storage knobs (Fig. D)
8 and lower breaker on to cart.
2 .
10 (location shown in Fig. D).
9 .
and slowly tilt breaker truck back so it
1
Fig. A
3
7
8
Fig. B
11
Fig. D
.
11
1
Fig. C
3
8
10
9
WALT
e
2
6
4
5