Skullcandy BARREL Guia De Inicio Rapido

MANUAL (EN)
FRONT PANEL
BARREL
FULLY IMMERSIVE SOUND FOR YOU AND YOUR CREW
STRAP CLIPS
POWER ON / OFF / TWS PAIRING
LED BATTERY INDICATOR
LIGHT SHOW MODE
BLUETOOTH
®
PAIRING
VOLUME DOWN /
PREVIOUS TRACK
PLAY / PAUSE / BASS BOOST
VOLUME UP /
NEXT TRACK
FCC Warning
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's
authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference
to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that
to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
Canada warning:
- English:
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: This device may
not cause interference. This device must accept any interference, including interference that may cause undesired
operation of the device.
The device has been evaluated to meet general RF exposure requirement. The device
can be used in portable exposure condition without restriction.
- French:
Cet appareil contient des émetteurs/récepteurs exemptés de licence qui sont conformes aux flux RSS exemptés de
licence de Innovation, Science et développement économique Canada. L'exploitation est soumise aux deux conditions
suivantes: Cet appareil ne doit pas causer d'interférences. Ce dispositif doit accepter toute interférence, y compris
toute interférence pouvant causer un fonctionnement indésirable du dispositif.
1 YEAR WARRANTY
MODEL: 2SKSK1849
Website: Skullcandy.com Support: 877-543-3540
STICKER PACK
BACK PANEL PORTS:
AUX 3.5MM AUDIO INPUT
USB-A AUDIO INPUT / POWER OUTPUT
USB-C POWER OUTPUT
DC POWER INPUT
*PORT COVER MUST BE CLOSED TO
ALLOW FOR IPX5 WATER PROTECTION
Packaging includes:
(1) Barrel™ Speaker
(1) 10ft Charging Adapter
(1) Carry Strap
(1) User Manual
FUNCTIONS
Power ON / OFF:
Press and hold the "O" button for 2s. If not connected to a Bluetooth®
device or connected but idle (not playing audio) the speaker will turn OFF
automatically after 15 min.
Play / Pause:
Press the " " button once to play or pause audio.
Volume up:
Press "+" button to increase the volume.
Volume Down:
Press "-" button to decrease the volume.
Next Track:
Press and hold "+" button for 2s to skip track.
Previous Track:
Press and hold "-" button for 2s to go to last track.
Bluetooth Pairing:
®
First disconnect the speaker from any AUX or USB-A inputs. Then press and
hold the "Bluetooth®" button for 2s to enter Bluetooth® Pairing Mode. The
speaker will disconnect from any paired device and will become available to
pair to new devices. The speaker will stay in pairing mode for 60s, or until
connected. Status LED will blink blue while in Bluetooth® Pairing Mode.
True Wireless Stereo Pairing:
Press the "O" button three times to pair any two Barrel™ speakers to play
audio in stereo. Status LED will be cyan to indicate Right channel and yellow
to indicate Left channel (before TWS pairing, make sure that only one of the
speakers is connected to an audio source).
Exit True Wireless Stereo Mode:
Press the "O" button three times to exit TWS pairing.
SKDY Multi-link™ Transmitting:
First, connect one Barrel™ Speaker to Bluetooth®, AUX, or USB-A audio input.
Then press and hold the " " and "+" button together for 1s to set the speaker
as transmitting. Status LED will be purple.
SKDY Multi-link™ Mode Receiving:
First, disconnect the speaker from any Bluetooth® device by pressing and
holding the Bluetooth® button for 2s. Disconnect the speaker from any AUX or
USB-A inputs. Then press and hold the " " and "+" button together for 1s to
set the speaker as receiving. Status LED will be green. Up to 99 receiving
speakers can be connected to a single transmitting speaker.
Check Battery Status:
The 4 LED indicators show the battery level. Press and hold "+" and "-" buttons
together for 1s to initiate a voice prompt of the battery level.
Bass Boost
Bass Boost - Press and hold the "Play" button for 2s to toggle Bass Boost mode
ON/OFF. The " " button will be illuminated while the speaker is in Bass Boost Mode.
Light Show ON/OFF
Press and hold the "Light Show" button for 2s.
Light Show Change Mode
Press the "Light Show" button once to cycle between the light show modes.
Dual-Device Connection:
You can pair two transmitting devices (mobile phones for example) to the
Barrel™ speaker at the same time to DJ together. Pause the music on the
first device to play a song from the second device.
Charge Out:
While the speaker is ON: Plug in a USB-C™ or USB-A cable to begin charging
your compatible portable device automatically.
CHARGING THE BARREL™
Use the included charging adapter to connect the speaker to an appropriate
power source to begin charging. The LED indicators will show the battery is
charging. When all 4 LEDs are ON, the battery is fully charged.
Warning:
1. To avoid damage to the speaker and battery, it is important to only use a
power source that matches the power requirements listed on the speaker's
rating label.
2. To avoid overheating, it's recommended not to place the speaker in direct
sunlight, especially while charging and playing music.
Battery Status Indication (not charging):
0-5% - speaker is OFF all 4 LEDs are OFF
5-10% - 1st LED blinks red, other LEDs are OFF
10-25% - 1st LED is ON white, other LEDs are OFF
25-50% - 1st + 2nd LEDs are ON white, other LEDs are OFF
50-75% - 1st + 2nd + 3rd LEDs are ON white, other LEDs are OFF
75-100% - All LEDs are ON white
Battery Status Indication (while charging):
0-25% - 1st LED blinks white, other LEDs are OFF
25-50% - 1st LED is ON white, 2nd LED is blinking.
Other LEDs are OFF
50-75% - 1st + 2nd LEDs are ON white, 3rd LED is blinking.
Other LEDs are OFF
75-99% - 1st + 2nd + 3rd LEDs are ON white, 4th LED is blinking.
Other LEDs are OFF
100% - All LEDs are ON for 1 minute, then OFF
CONNECTION PRIORITY
AUX > USB > BT (Bluetooth®)
To play from an AUX source, simply plug in an AUX cable to the speaker and
your audio source device. It will automatically have priority over USB and BT.
To play from a USB source, plug in a USB flash drive and make sure that AUX
is disconnected. It will automatically have priority over BT (but not over AUX).
To play from BT source, connect a Bluetooth® enabled device and make sure
that AUX and USB are disconnected.
TROUBLE SHOOTING
Factory Reset:
Press and hold "-" and "+" buttons at the same time for 10s to initiate factory
reset. The speaker will revert to factory settings and all previously paired
devices will be deleted. Status LED will blink between blue and red while
resetting.
Speaker is not Playing Wirelessly:
If the speaker is not playing audio although it's connected to a Bluetooth™
device, it may be because of the audio connection priority. Disconnect any
AUX or USB-A cables that may be connected to the speaker and try again.
SPECIFICATIONS 2023© Skullcandy is a registered trademark Marketed
and distributed by Lifeworks technology Group LLC., New
Bluetooth® Version：5.3
York, NY 10018. USB Type-A™, USB Type-C™ and
Battery Capacity: 11.1V/4400mAh
USB-C™ are trademarks of USB Implementers Forum.
Charging Input: DC 22V/3.2A
The Bluetooth® word mark and logos are registered
Play Time: Up to 12 hours*
trademarks owned by Bluetooth SIG, Inc. and any use of
Charging Time: 3.5 hours
such marks by Lifeworks Technology Group LLC. is under
Operating Range: 10M license. All brands are registered trademarks of their
respective companies. *Actual product may differ slightly
Rated Power: 60W
from images. *Battery playtime is based on 77 SPL (C),
Audio Inputs: Bluetooth®, USB-A, Aux 3.5mm
actual playtime will vary based on song type and playing
Charging Outputs: USB-C, USB-A
conditions. Made in China.
Battery Standby Time: 365 Days
IPX Rating: IPX5 (water resistant)
EN: SCAN FOR SUPPORT
FR: NUMÉRISER POUR OBTENIR UN SOUTIEN
ES: ESCANEAR PARA OBTENER ASISTENCIA
PL: ZESKANUJ, ABY UZYSKAĆ POMOC
SV: SKANNA FÖR SUPPORT
NL: SCANNEN VOOR ONDERSTEUNING
IT: SCANSIONE PER ASSISTENZA
DE: FÜR SUPPORT SCANNEN
BACK PANEL
Double sided pritning - Accordian Style Booklet